dorsal team mailing list archive

[Anders Logg <logg@xxxxxxxxx>]

On Wed, Aug 18, 2010 at 01:46:18PM +0200, Anders Logg wrote:
> On Wed, Aug 18, 2010 at 12:43:23PM +0100, Garth N. Wells wrote:
> > On Wed, 2010-08-18 at 13:38 +0200, Anders Logg wrote:
> > > I'm getting the following error message when installing with Dorsal on
> > > my Snow Leopard MacBook:
> > >
> > > Unpacking slepc-3.1-p1
> > > Building slepc-3.1-p1
> > > Checking environment...
> > > Checking PETSc installation...
> > > Checking LAPACK library...
> > >
> > > ================================================================================
> > > SLEPc Configuration
> > > ================================================================================
> > >
> > > SLEPc source directory:
> > >  /Users/logg/Work/FEniCS/src/slepc-3.1-p1
> > > SLEPc install directory:
> > >  /Users/logg/Work/FEniCS
> > > PETSc directory:
> > >  /Users/logg/Work/FEniCS
> > > Architecture "unknown" with double precision real numbers
> > >
> > >   **
> > >   ** Before running "make" your PETSC_ARCH must be specified with:
> > >   **  ** setenv PETSC_ARCH unknown (csh/tcsh)
> > >   **  ** PETSC_ARCH=unknown ; export PETSC_ARCH (sh/bash)
> > >   **
> > >
> > > makefile:30: darwin10.0.0-cxx-opt/conf/slepcvariables: No such file or
> > > directory
> > > /Users/logg/Work/FEniCS/src/slepc-3.1-p1/conf/slepc_common_variables:2:
> > > /Users/logg/Work/FEniCS/src/slepc-3.1-p1/darwin10.0.0-cxx-opt/conf/slepcvariables:
> > > No such file or directory
> > > /Users/logg/Work/FEniCS/src/slepc-3.1-p1/conf/slepc_common_rules:78:
> > > /Users/logg/Work/FEniCS/src/slepc-3.1-p1/darwin10.0.0-cxx-opt/conf/slepcrules:
> > > No such file or directory
> > > make: *** No rule to make target
> > > `/Users/logg/Work/FEniCS/src/slepc-3.1-p1/darwin10.0.0-cxx-opt/conf/slepcrules'.
> > > Stop.
> > > Failure with exit status: 2
> > > Exit message: There was a problem building slepc-3.1-p1.
> > >
> > > Any ideas what goes wrong?
> > >
> >
> > I thought that I fixed this yesterday. See if you can figure out what's
> > going on in
> >
> >     FEniCS/packages/slepc.package
> >
> > Garth
>
> ok.

The problem seems to be PETSC_ARCH_TEMP. The way I understand this is
that this should be set in package_specific_register as part of
petsc.package and then propagated to slepc.package, but that variable
seems to be empty (in both petsc.package and slepc.package).

Where is PETSC_ARCH set?

--
Anders

Attachment: signature.asc
Description: Digital signature