← Back to team overview

group.of.nepali.translators team mailing list archive

[Bug 1696162] Re: brcmfmac does not support unbinding

 

This bug was fixed in the package nplan - 0.23~16.04.1

---------------
nplan (0.23~16.04.1) xenial; urgency=medium

  * Backport netplan 0.23 to 16.04. (LP: #1688632)

nplan (0.23) artful; urgency=medium

  * Do not unbind brcmfmac, interface will be gone. (LP: #1696162)

nplan (0.22) artful; urgency=medium

  * Add support for setting a custom MAC address on all device types.
    (LP: #1690388)
  * Improved MAC/vlan integration tests; thanks for Dimitri John Ledkov for the
    changes.

nplan (0.21) artful; urgency=medium

  [ Ryan Harper ]
  * Add support for setting MTU on a device. (LP: #1668693)

  [ Mathieu Trudel-Lapierre ]
  * Don't rebind Atheros AR9271; it would confuse the driver. (LP: #1672740)
  * debian/control: Add Conflicts: against netplan; the network 'plan' daemon.
    Both ship the same /usr/sbin/netplan. (LP: #1665842)

nplan (0.20) zesty; urgency=medium

  * tests/integration.py: increase timeout for integration tests (networkd and
    NetworkManager "wait-online" checks) to account for longer bring-up times
    when dealing with stacked virtual devices.

nplan (0.19) zesty; urgency=medium

  * Add support for unordered definition of network devices: you can now
    specify a virtual devices before their member devices. (LP: #1670495)
  * Allow setting up the STP state for a bridge. (LP: #1665088)
  * Document bond/bridge parameters support. (LP: #1664702)

nplan (0.18) zesty; urgency=medium

  * debian/tests/integration.py: in some cases 'iw reg get' may qualify the
    reg domain results with 'global'; we must not let that trip up tests when
    they are run on Ubuntu infrastructure vs. local tests.

nplan (0.17) zesty; urgency=medium

  * New release:
    - Add support for configuring bonds.
    - Add support for configuring bridges.

nplan (0.16) zesty; urgency=medium

  [ Martin Pitt ]
  * doc/example-config: Adjust "routes:" example.
    It does not make sense to make "routes:" a global thing, they should be
    tied to an interface so that the route is only set when the corresponding
    interface exists and is up, and the config is not split in two parts.
  * doc/netplan.md: Point out that NM does not support globbing (LP: #1631018)

  [ Mathieu Trudel-Lapierre ]
  * Fix coverage for src/netplan to be 100%, and fail if coverage falls below
    that mark again.
  * Add support for specifying routes.

nplan (0.15) zesty; urgency=medium

  * tests/generate.py: Fix PEP-8 error (newly detected by -proposed
    pycodestyle).

 -- Mathieu Trudel-Lapierre <cyphermox@xxxxxxxxxx>  Tue, 06 Jun 2017
17:19:10 -0700

** Changed in: nplan (Ubuntu Xenial)
       Status: Fix Committed => Fix Released

-- 
You received this bug notification because you are a member of नेपाली
भाषा समायोजकहरुको समूह, which is subscribed to Xenial.
Matching subscriptions: Ubuntu 16.04 Bugs
https://bugs.launchpad.net/bugs/1696162

Title:
  brcmfmac does not support unbinding

Status in nplan package in Ubuntu:
  Fix Released
Status in nplan source package in Xenial:
  Fix Released
Status in nplan source package in Yakkety:
  Fix Committed
Status in nplan source package in Zesty:
  Fix Committed

Bug description:
  [Impact]
  Don't unbind brcmfmac_sdio; the driver does not support unbinding (the interface would be gone otherwise).

  [Test case]
  1) Run on a system with brcmfmac driver
  2) Verify that 'netplan apply' works for the selected configuration and the interface is not removed.

  [Regression potential]
  Failure to properly configure brmcfmac or if the interface gets removed after 'netplan apply' would be a regression.

To manage notifications about this bug go to:
https://bugs.launchpad.net/ubuntu/+source/nplan/+bug/1696162/+subscriptions


References