group.of.nepali.translators team mailing list archive

[Launchpad Bug Tracker <1720977@xxxxxxxxxxxxxxxxxx>]

This bug was fixed in the package linux - 4.10.0-38.42

---------------
linux (4.10.0-38.42) zesty; urgency=low

  * linux: 4.10.0-38.42 -proposed tracker (LP: #1722330)

  * Controller lockup detected on ProLiant DL380 Gen9 with P440 Controller
    (LP: #1720359)
    - scsi: hpsa: limit transfer length to 1MB

  * [Dell Docking IE][0bda:8153] Realtek USB Ethernet leads to system hang
    (LP: #1720977)
    - r8152: fix the list rx_done may be used without initialization

  * Touchpad not detected in Lenovo X1 Yoga / Yoga 720-15IKB (LP: #1700657)
    - mfd: intel-lpss: Add missing PCI ID for Intel Sunrise Point LPSS devices

  * Add installer support for Broadcom BCM573xx network drivers. (LP: #1720466)
    - d-i: Add bnxt_en to nic-modules.

  * CVE-2017-1000252
    - KVM: VMX: Do not BUG() on out-of-bounds guest IRQ

  * CVE-2017-10663
    - f2fs: sanity check checkpoint segno and blkoff

  * xfstest sanity checks on seek operations fails (LP: #1696049)
    - xfs: fix off-by-one on max nr_pages in xfs_find_get_desired_pgoff()

  * [P9, Power NV][ WSP][Ubuntu 16.04.03] : perf hw breakpoint command results
    in call traces and system goes for reboot. (LP: #1706033)
    - powerpc/64s: Handle data breakpoints in Radix mode

  * 5U84 - ses driver isn't binding right - cannot blink lights on 1 of the 2
    5u84 (LP: #1693369)
    - scsi: ses: do not add a device to an enclosure if enclosure_add_links()
      fails.

  * Vlun resize request could fail with cxlflash driver (LP: #1713575)
    - scsi: cxlflash: Fix vlun resize failure in the shrink path

  * More migrations with constant load (LP: #1713576)
    - sched/fair: Prefer sibiling only if local group is under-utilized

  * New PMU fixes for marked events. (LP: #1716491)
    - powerpc/perf: POWER9 PMU stops after idle workaround

  * CVE-2017-14340
    - xfs: XFS_IS_REALTIME_INODE() should be false if no rt device present

  * [Zesty][Yakkety] rtl8192e bug fixes (LP: #1698470)
    - staging: rtl8192e: rtl92e_fill_tx_desc fix write to mapped out memory.
    - staging: rtl8192e: fix 2 byte alignment of register BSSIDR.
    - staging: rtl8192e: rtl92e_get_eeprom_size Fix read size of EPROM_CMD.
    - staging: rtl8192e: GetTs Fix invalid TID 7 warning.

  * Stranded with ENODEV after mdadm --readonly (LP: #1706243)
    - md: MD_CLOSING needs to be cleared after called md_set_readonly or
      do_md_stop

  * multipath -ll is not showing the disks which are actually multipath
    (LP: #1718397)
    - fs: aio: fix the increment of aio-nr and counting against aio-max-nr

  * ETPS/2 Elantech Touchpad inconsistently detected (Gigabyte P57W laptop)
    (LP: #1594214)
    - Input: i8042 - add Gigabyte P57 to the keyboard reset table

  * CVE-2017-10911
    - xen-blkback: don't leak stack data via response ring

  * CVE-2017-11176
    - mqueue: fix a use-after-free in sys_mq_notify()

  * implement 'complain mode' in seccomp for developer mode with snaps
    (LP: #1567597)
    - Revert "UBUNTU: SAUCE: seccomp: log actions even when audit is disabled"
    - seccomp: Provide matching filter for introspection
    - seccomp: Sysctl to display available actions
    - seccomp: Operation for checking if an action is available
    - seccomp: Sysctl to configure actions that are allowed to be logged
    - seccomp: Selftest for detection of filter flag support
    - seccomp: Action to log before allowing

  * implement errno action logging in seccomp for strict mode with snaps
    (LP: #1721676)
    - Revert "UBUNTU: SAUCE: seccomp: log actions even when audit is disabled"
    - seccomp: Provide matching filter for introspection
    - seccomp: Sysctl to display available actions
    - seccomp: Operation for checking if an action is available
    - seccomp: Sysctl to configure actions that are allowed to be logged
    - seccomp: Selftest for detection of filter flag support
    - seccomp: Filter flag to log all actions except SECCOMP_RET_ALLOW

  * Backport recent bbr bugfixes to 4.10 kernel (LP: #1708604)
    - tcp_bbr: cut pacing rate only if filled pipe
    - tcp_bbr: introduce bbr_bw_to_pacing_rate() helper
    - tcp_bbr: introduce bbr_init_pacing_rate_from_rtt() helper
    - tcp_bbr: remove sk_pacing_rate=0 transient during init
    - tcp_bbr: init pacing rate on first RTT sample

  * [SRU][Zesty] Fix lscpu segfault on ARM64 with SMBIOS v2.0 (LP: #1716483)
    - arm64: kernel: restrict /dev/mem read() calls to linear region

 -- Kleber Sacilotto de Souza <kleber.souza@xxxxxxxxxxxxx>  Tue, 10 Oct
2017 13:49:34 +0200

** Changed in: linux (Ubuntu Zesty)
       Status: Fix Committed => Fix Released

** CVE added: https://cve.mitre.org/cgi-
bin/cvename.cgi?name=2017-1000252

** CVE added: https://cve.mitre.org/cgi-bin/cvename.cgi?name=2017-10663

** CVE added: https://cve.mitre.org/cgi-bin/cvename.cgi?name=2017-10911

** CVE added: https://cve.mitre.org/cgi-bin/cvename.cgi?name=2017-11176

** CVE added: https://cve.mitre.org/cgi-bin/cvename.cgi?name=2017-14340

-- 
You received this bug notification because you are a member of नेपाली
भाषा समायोजकहरुको समूह, which is subscribed to Xenial.
Matching subscriptions: Ubuntu 16.04 Bugs
https://bugs.launchpad.net/bugs/1720977

Title:
  [Dell Docking IE][0bda:8153] Realtek USB Ethernet leads to system hang

Status in HWE Next:
  Fix Committed
Status in linux package in Ubuntu:
  Fix Committed
Status in linux source package in Xenial:
  Fix Committed
Status in linux source package in Zesty:
  Fix Released

Bug description:
  [Impact]
  There is a USB Ethernet port, 0bda:8153, on Dell IE Docking.
  After plugged in the docking, system hard hangs.

  [Fix]
  This issue has been fix after v4.11-rc4, so after bisecting the kernel, we found the first bad commit, and realized this issue is from Realtek USB Ethernet driver with a non-initialized list.
     98d068a r8152: fix the list rx_done may be used without initialization

  [Test Case]
  Verified on the Dell XPS and IE docking, and confirm this patch works.

  [Regression Potential]
  It's a one line patch and do the initialization of the list variable, there should be no any regression would be resulted from this.

To manage notifications about this bug go to:
https://bugs.launchpad.net/hwe-next/+bug/1720977/+subscriptions