kicad-developers team mailing list archive
Mailing list archive
Re: possible typo or not? $EndSCHEMATC
On Sun, Aug 19, 2012 at 04:22:33PM +0200, Edwin van den Oetelaar wrote:
> Should this not read "$EndSchematic\n"
> to be consistent?
> It appears that during reading of the file just "$End" is matched.
Exactly, so in practice it doesn't matter XD eeschema parser is easy to
please as you can see
> Is there a definition somewhere?
File format in kicad-doc, not fully updated but that's ancient stuff
anyway (IIRC it always was written this way)