On Sat, May 04, 2013 at 03:29:07PM +0200, jp charras wrote:
Be sure the solder mask visibility (which covers the holes, and is
now displayed) is set to invisible to show holes.
OK, that was the problem. It's misleading since where there are a few
choices to enable/disable layers from the viewer menu, the masks are
controlled by the main board view controls.
Probably the 'best' way to handle this would be a layer toolbar instance
in the 3D viewer window; is it feasible? (i.e. not too many static ties
from the layer bar to the frame or something preventing multiple
instantiation)
