kicad-developers team mailing list archive

[Wayne Stambaugh <stambaughw@xxxxxxxxxxx>]

On 4/15/2014 1:37 AM, Dick Hollenbeck wrote:
> On 04/14/2014 08:56 PM, Wayne Stambaugh wrote:
>> On 4/14/2014 3:14 PM, Dick Hollenbeck wrote:
>>> On 04/14/2014 02:03 PM, Wayne Stambaugh wrote:
>>>> On 4/14/2014 2:37 PM, Dick Hollenbeck wrote:
>>>>> On 04/14/2014 01:20 PM, Wayne Stambaugh wrote:
>>>>>> I was working on a project with a project specific footprint library
>>>>>> table when I noticed that it appeared to have all of the default legacy
>>>>>> footprint libraries instead of the libraries that I had defined.  I went
>>>>>> and looked at the project fp-lib-table and sure enough it only had the
>>>>>> two custom libraries that I originally added to it.  Upon further
>>>>>> inspection I noticed that KIPRJMOD is incorrectly pointing to system
>>>>>> template path instead of the project path (see attached image).  Is
>>>>>> anyone else seeing this?  This used to work just fine.  Did someone
>>>>>> change the CWD code recently?
>>>>>>
>>>>>> Wayne
>>>>>
>>>>>
>>>>> Your graphic is not showing the project specific tab.  So I think I have no starting point
>>>>> in understanding your bug report.
>>>>>
>>>>
>>>> Here is the fp-lib-table editor image with the project tab selected.
>>>> The problem is that KIPRJMOD is defined as the template path (I selected
>>>> it to highlight it) even though the netlist file that is open is in the
>>>> project folder that contains a valid fp-lib-table file.  I looked at the
>>>> fp-lib-table in the template folder and sure enough that is the
>>>> fp-lib-table that is being loaded instead of the project fp-lib-table
>>>> file.  There are only two entries in the project fp-lib-table.
>>>
>>>
>>> I'd put breakpoint at
>>>
>>>
>>> 1) line 58 of common/project.cpp
>>> 2) line 94 of common/project.cpp
>>>
>>>
>>> Check the call stack when you hit either of those.
>>> Check the full name of the project at either place.
>>>
>>> At line 94 the flow should go to the else.
>>>
>>
>> I uncommented the wxLogDebug call in PROJECT::SetProjectFullName() and
>> here is the debugging output after opening a project netlist with CvPcb:
>>
>> [900] Setting env KIPRJMOD to 'C:\Users\Wayne\Documents\Motion
>> Sensors\pca174'.
>> [900] Setting env KIPRJMOD to
>> 'E:\MinGW\msys\1.0\home\Wayne\share\template'.
>>
>> SetProjectFullName() is getting called a second time with the template
>> path which is overwriting the correct project path.  If I get some time
>> tomorrow, I'll see if I can find the time to dump the call stack to find
>> the where second offending call is coming from.
> 
> 
> Try version 4802, which I futzed with.   Hopefully 4802 works better.
> 
> I suspect your *.pro file might have been a "version 0" file?
> 
> Sorry for the inconvenience.
> 
> Dick
> 

Thanks, that fixed it!

Wayne