kicad-developers team mailing list archive

[José Eduardo S. C. Xavier <josescxavier@xxxxxxxxxxx>]

Pads 50 are there only to paste stencil format.

But both Bottom and Top pad are number 49 that in schecmatic is connected
to GND.

2014-12-12 13:36 GMT+00:00 LordBlick <lordblick@xxxxxxxxx>:

> In response to a message written on 12.12.2014, 14:32, from LordBlick:
>
>> In response to a message written on 12.12.2014, 13:36, from José Eduardo
>> S. C.
>> Xavier:
>>
>>> Hi,
>>>
>>> DRC check is saying that the a PAD isn't connect but it is connected.
>>> You can
>>> see in the video what is happening:
>>> https://www.dropbox.com/s/g9582x45psmjtid/error_drc.ogg?dl=0
>>>
>>> The project board: https://www.dropbox.com/s/
>>> j5wd9xzpvcrytix/pcb.zip?dl=0
>>>
>>> To solve that DRC error I need to remove the bottom pad 49 on the IC1
>>> that was
>>> first add to make the bottom to look better, without that it looks
>>> something
>>> like that: http://i.imgur.com/erqkX3x.png.
>>>
>>>
>>> What is causing that DRC error?
>>>
>>> PS: I than realize that I didn't need that pad and only need to change
>>> the pad
>>> connection on each hole to solid to make it look good.
>>>
>> Its bad idea that some SMD componens have some elements on Bottom layer.
>>
> Independly, pads „50” have not defined any net connection
>
>
> --
> Best Regards,
> LordBlick
>
> _______________________________________________
> Mailing list: https://launchpad.net/~kicad-developers
> Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~kicad-developers
> More help   : https://help.launchpad.net/ListHelp
>