kicad-developers team mailing list archive

[Nick Østergaard <oe.nick@xxxxxxxxx>]

Have you tried connectong the nets? To me it do indeed look like you have
two nets seperated, hence it is un connected.
Den 30/12/2014 17.43 skrev "Andy Peters" <devel@xxxxxxxxx>:

> I'm using my build of BZR 5337 on OS X 10.10.1 (same problem on 10.9.5).
>
> I have a completely routed design, not all that complicated, and the DRC
> is throwing an odd message:
>
> ErrType(2): Unconnected pads
>     * @(4.7063 in,6.6754 in): Pad 8 on F.Cu, Non-copper of U6 net +15V
>     * @(4.7112 in,5.6410 in): Pad 1 on B.Cu, Non-copper of C40
>
> U6 is an IC; Pin 8 is its VCC pin that connects to the +15V net. C40 is a
> decoupling cap that is hanging on the +15V net. But U6 is not near C40.
>
> I've attached a screen shot. It's hard to see, but the +15V trace does
> connect to the capacitor and the IC pin. C40 is on the back of the board,
> near the top center of the image. U6 is on the front of the board, sort of
> middle, closer to the bottom edge of the image.
>
> "Non-copper" implies soldermask or perhaps silkscreen; why would that even
> be an issue here?
>
> Thanks for ideas ...
>
>
> _______________________________________________
> Mailing list: https://launchpad.net/~kicad-developers
> Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~kicad-developers
> More help   : https://help.launchpad.net/ListHelp
>
>