kicad-developers team mailing list archive

[Tom Andrews <gta4lj@xxxxxxxxx>]

Hi guys,

Whilst working with boards on GAL, after closing and reopening boards, as
well as sometimes whilst just leaving a board open, unconnected nets are
forgotten and unconnected nets/planes aren't listed in the bar below
(unconnected: 0), nor is there a ratsnest line.

Running a DRC doesn't fix this, only manually finding unlinked nets or
changing to legacy fixes this.

Also whilst working with planes, sometimes ratsnest lines are drawn between
bits of the plane that are definitely connected, also fixed by moving back
to legacy.

Both seem intermittent as it doesn't happen every time.

Not sure if this is a known issue, but any advice to pin down the issue
would be appreciated.

Cheers,

Tom