kicad-developers team mailing list archive
-
kicad-developers team
-
Mailing list archive
-
Message #23145
Re: PATCH: Set SMD attribute in footprint wizard
-
To:
kicad-developers@xxxxxxxxxxxxxxxxxxx
-
From:
Clemens Koller <cko@xxxxxxxxx>
-
Date:
Tue, 16 Feb 2016 11:59:05 +0100
-
In-reply-to:
<CAJ=c1uRmD3a9Cggj3KMe-bicpZ97K1L4C=fukyVFSVj6VW-rcQ@mail.gmail.com>
-
User-agent:
Mozilla/5.0 (X11; Linux x86_64; rv:38.0) Gecko/20100101 Thunderbird/38.5.1
Hello!
On 2016-02-16 09:30, Mikael Arguedas wrote:
> If you are implementing the ceiling function in a parent class, use 0.05
> mm, because it will be not necessary used for sizes, but also for
> distances, and round the half size if needed.
Ok, I might be nitpicking again:
Can we make that rounding value configurable?
I would call this minimum drafting design width/gap.
With smaller and smaller SMD sizes, even 0.025mm is a quite
coarse grid/minimum width size. I ended up with 0.01mm.
I have already 0603M (0201) 0402M (01005) 03015M (008004) (M=metric)
sizes arriving in my calculations... @:-|
Regards,
Clemens
Follow ups
References
-
PATCH: Set SMD attribute in footprint wizard
From: Mikael Arguedas, 2016-02-12
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Mikael Arguedas, 2016-02-12
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Miguel Angel Ajo Pelayo, 2016-02-12
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Mikael Arguedas, 2016-02-12
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Mikael Arguedas, 2016-02-14
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Miguel Angel Ajo Pelayo, 2016-02-15
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Mikael Arguedas, 2016-02-16
-
Re: PATCH: Set SMD attribute in footprint wizard
From: jp charras, 2016-02-16
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Mikael Arguedas, 2016-02-16
-
Re: PATCH: Set SMD attribute in footprint wizard
From: jp charras, 2016-02-16
-
Re: PATCH: Set SMD attribute in footprint wizard
From: Mikael Arguedas, 2016-02-16