kicad-developers team mailing list archive

[Simon Wells <swel024@xxxxxxxxx>]

do they not have the difference of being limited to only 1 decimal
place unlike the others though?

On Sun, Apr 10, 2016 at 3:27 AM, Chris Pavlina <pavlina.chris@xxxxxxxxx> wrote:
> Values already have to be validated. The only issue I can think of is related
> to the decimal point / comma issue, but we're *already* accepting decimal
> points in values in other fields in the same dialogs (for positional offsets,
> for instance). I figure it should be fine as long as they're handled in the
> same way.
>
> On Sun, Apr 10, 2016 at 03:16:53AM +1200, Simon Wells wrote:
>> This was seen in a previous thread iirc and wayne mentioned that
>> someone would need to write it so that it verified values were entered
>> correctly etc
>>
>> On Sun, Apr 10, 2016 at 2:37 AM, Chris Pavlina <pavlina.chris@xxxxxxxxx> wrote:
>> > Anyone mind if I go through and fix the "in 0.1 degrees" units that are all
>> > over pcbnew? I don't see any reason why we can't let the user enter unit
>> > degrees with a decimal point.
>> >
>> > --
>> > Chris
>> >
>> > _______________________________________________
>> > Mailing list: https://launchpad.net/~kicad-developers
>> > Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
>> > Unsubscribe : https://launchpad.net/~kicad-developers
>> > More help   : https://help.launchpad.net/ListHelp