kicad-developers team mailing list archive

[Chris Pavlina <pavlina.chris@xxxxxxxxx>]

The others also have a minimum resolution too, unless you think you can align
things to femtometers ;)

On Sun, Apr 10, 2016 at 03:38:08AM +1200, Simon Wells wrote:
> do they not have the difference of being limited to only 1 decimal
> place unlike the others though?
> 
> On Sun, Apr 10, 2016 at 3:27 AM, Chris Pavlina <pavlina.chris@xxxxxxxxx> wrote:
> > Values already have to be validated. The only issue I can think of is related
> > to the decimal point / comma issue, but we're *already* accepting decimal
> > points in values in other fields in the same dialogs (for positional offsets,
> > for instance). I figure it should be fine as long as they're handled in the
> > same way.
> >
> > On Sun, Apr 10, 2016 at 03:16:53AM +1200, Simon Wells wrote:
> >> This was seen in a previous thread iirc and wayne mentioned that
> >> someone would need to write it so that it verified values were entered
> >> correctly etc
> >>
> >> On Sun, Apr 10, 2016 at 2:37 AM, Chris Pavlina <pavlina.chris@xxxxxxxxx> wrote:
> >> > Anyone mind if I go through and fix the "in 0.1 degrees" units that are all
> >> > over pcbnew? I don't see any reason why we can't let the user enter unit
> >> > degrees with a decimal point.
> >> >
> >> > --
> >> > Chris
> >> >
> >> > _______________________________________________
> >> > Mailing list: https://launchpad.net/~kicad-developers
> >> > Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
> >> > Unsubscribe : https://launchpad.net/~kicad-developers
> >> > More help   : https://help.launchpad.net/ListHelp