kicad-developers team mailing list archive

[Diogo Condeço <diogocondeco@xxxxxxxxx>]

Is there any objection to change the dialog validation of the spoke width
to allow it to be greater or *equal* than the minimum width? Currently it
has to be greater... But if you allow for that minimum width one would
assume you could use it in the spokes width...

If there isn't an objection the following patch should do it. Also the
message is updated.

Thanks
-- 
Diogo Condeço

Attachment: 0001-Zone-properties-patch-to-allow-spoked-width-be-equal.patch
Description: Binary data