← Back to team overview

kicad-developers team mailing list archive

Re: Copper Zone Minimum width vs spoke width

 

Yes the patch is not really working... sorry too many builds :D

On Fri, Feb 3, 2017 at 5:49 PM, jp charras <jp.charras@xxxxxxxxxx> wrote:

> Le 03/02/2017 à 18:29, Diogo Condeço a écrit :
> > Is there any objection to change the dialog validation of the spoke
> width to allow it to be greater
> > or _*equal*_ than the minimum width? Currently it has to be greater...
> But if you allow for that
> > minimum width one would assume you could use it in the spokes width...
> >
> > If there isn't an objection the following patch should do it. Also the
> message is updated.
> >
> > Thanks
> > --
> > Diogo Condeço
> >
> Filling algorithm needs a spoke width > minimum width, not >= minimum
> width.
>
>
> --
> Jean-Pierre CHARRAS
>
> _______________________________________________
> Mailing list: https://launchpad.net/~kicad-developers
> Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~kicad-developers
> More help   : https://help.launchpad.net/ListHelp
>



-- 
Diogo Condeço

References