kicad-developers team mailing list archive

[Nick Østergaard <oe.nick@xxxxxxxxx>]

Isn't this the expected behavior?

Usually you can sort of trim a wire by drawing from the end of it and into
itself to remove that section.

2017-11-17 11:03 GMT+01:00 jp charras <jp.charras@xxxxxxxxxx>:

> Le 10/10/2017 à 07:19, Seth Hillbrand a écrit :
> > Sorry for the repeat on this one.  I missed a corner case in testing the
> first time (overlapping,
> > horizontal segments offset in Y)
> >
> > I've attached a collapsed patch for this.
> >
> > -Seth
> >
>
> Hi Seth,
>
> I tested you patch and unfortunately it did not very well.
>
> For instance a basic case:
>
> draw a horizontal wire from point A to Point B.
>
> Then draw a second wire from the middle of AB to B.
> the expected result is only on wire from A to B
> but the result is one shorter wire from A to the middle of AB.
>
>
> --
> Jean-Pierre CHARRAS
>
> _______________________________________________
> Mailing list: https://launchpad.net/~kicad-developers
> Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~kicad-developers
> More help   : https://help.launchpad.net/ListHelp
>