Wayne I still have an issue with silently breaking files. Using an
"offset" parameter (but reading "at" for compatibility) does not break
anyone's models and there is absolutely no confusion about which is mm
and which is inches. Incidentally I think "offset" is a better name, it
implies relative position rather than absolute (but that's neither here
nor there).
On Thu, Nov 23, 2017 at 7:55 AM, Marcos Chaparro <nitrousnrg@xxxxxxxxx
<mailto:nitrousnrg@xxxxxxxxx>> wrote:
On Wed, Nov 22, 2017 at 11:59 AM, Wayne Stambaugh
<stambaughw@xxxxxxxxx <mailto:stambaughw@xxxxxxxxx>> wrote:
Yes, it is a change that will break some users 3D models
but I think the long term benefit outweighs the short term
annoyance.
It will break most of my boards. I won't complain because I
appreciate the effort and I welcome *every* improvement, but be
prepared for some very rough comments out there.
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
<https://launchpad.net/~kicad-developers>
Post to : kicad-developers@xxxxxxxxxxxxxxxxxxx
<mailto:kicad-developers@xxxxxxxxxxxxxxxxxxx>
Unsubscribe : https://launchpad.net/~kicad-developers
<https://launchpad.net/~kicad-developers>
More help : https://help.launchpad.net/ListHelp
<https://help.launchpad.net/ListHelp>
_______________________________________________
Mailing list: https://launchpad.net/~kicad-developers
Post to : kicad-developers@xxxxxxxxxxxxxxxxxxx
Unsubscribe : https://launchpad.net/~kicad-developers
More help : https://help.launchpad.net/ListHelp