kicad-developers team mailing list archive
-
kicad-developers team
-
Mailing list archive
-
Message #32042
Re: [PATCH] Fix drag wire issue
Hi Wayne-
Thanks for testing. Oddly, I do not observe either of the effects you
describe on Mac or Linux (Debian), based off master (f992d144d). Are you
running Windows? If so, I'll try to find a VM to replicate this.
Best-
Seth
On Tue, Nov 28, 2017 at 12:43 PM, Wayne Stambaugh <stambaughw@xxxxxxxxx>
wrote:
> Seth,
>
> I just tested this. The disambiguation menu is shown but it still drags
> both lines and it breaks the undo as well. Maybe the undo part is fixed
> by your other patch set.
>
> Cheers,
>
> Wayne
>
> On 11/27/2017 5:51 PM, Seth Hillbrand wrote:
> > In Eeschema, if you draw two lines on top of each other that are not
> > the same type, e.g. wire and bus; or bus and graphic line, and then
> > hover over the lines and use the 'drag' hotkey, both lines will drag at
> > the same time. The correct behavior should show disambiguation.
> >
> > The attached patch corrects this behavior by distinguishing the line
> > types in SCH_COLLECTOR::IsCorner().
> >
> > Reference: https://bugs.launchpad.net/kicad/+bug/1635984
> >
> > -Seth
> >
> >
> >
> > _______________________________________________
> > Mailing list: https://launchpad.net/~kicad-developers
> > Post to : kicad-developers@xxxxxxxxxxxxxxxxxxx
> > Unsubscribe : https://launchpad.net/~kicad-developers
> > More help : https://help.launchpad.net/ListHelp
> >
>
> _______________________________________________
> Mailing list: https://launchpad.net/~kicad-developers
> Post to : kicad-developers@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~kicad-developers
> More help : https://help.launchpad.net/ListHelp
>
Follow ups
References