← Back to team overview

kicad-developers team mailing list archive

Re: wxGTK3 patches

 

On 2/7/2018 1:54 PM, jp charras wrote:
> Le 07/02/2018 à 19:44, Wayne Stambaugh a écrit :
>> If you are using a gal canvas, the only time you see the cross hairs is
>> when a tool is selected.  This is true of even the small cross hairs.
> 
> Yes, but if in Preferences/Display Options you enable "Always display crosshairs" you should have
> the crosshair cursor always displayed.

So that's what that option is for!  We really should change the text to
is "Always display crosshairs in modern canvas" since this has no effect
on the legacy canvas.

> 
>>
>> On 2/7/2018 1:41 PM, Bernhard Stegmaier wrote:
>>> Yes, did see the button (synced today).
>>> But it didn’t seem to change anything.
>>> Where should I see it?
>>>
>>>> On 7. Feb 2018, at 19:39, Jeff Young <jeff@xxxxxxxxx> wrote:
>>>>
>>>> The crosshairs should be available again in a current build.  Do you see the toolbar button on the left?
>>>>
>>>>> On 7 Feb 2018, at 17:36, Bernhard Stegmaier <stegmaier@xxxxxxxxxxxxx> wrote:
>>>>>
>>>>> … yes, no good.
>>>>> It seems to be OK when just panning around.
>>>>> But, it gets very laggy while e.g. dragging/moving symbols around (even on a not so big schematic I had at hand).
>>>>>
>>>>> It is fine if you take out the Refresh() quoted below on macOS.
>>>>> I didn’t see any obvious things on a quick check with the remaining changes (might be due to the fact that crosshair is still disabled on macOS?).
>>>>>
>>>>>
>>>>> Regards,
>>>>> Bernhard
>>>>>
> 
> 


Follow ups

References