kicad-developers team mailing list archive

[Jeff Young <jeff@xxxxxxxxx>]

We already did.  Well: “Always display crosshairs (not in Legacy)”, anyway.


> On 7 Feb 2018, at 19:21, Wayne Stambaugh <stambaughw@xxxxxxxxx> wrote:
> 
> On 2/7/2018 1:54 PM, jp charras wrote:
>> Le 07/02/2018 à 19:44, Wayne Stambaugh a écrit :
>>> If you are using a gal canvas, the only time you see the cross hairs is
>>> when a tool is selected.  This is true of even the small cross hairs.
>> 
>> Yes, but if in Preferences/Display Options you enable "Always display crosshairs" you should have
>> the crosshair cursor always displayed.
> 
> So that's what that option is for!  We really should change the text to
> is "Always display crosshairs in modern canvas" since this has no effect
> on the legacy canvas.
> 
>> 
>>> 
>>> On 2/7/2018 1:41 PM, Bernhard Stegmaier wrote:
>>>> Yes, did see the button (synced today).
>>>> But it didn’t seem to change anything.
>>>> Where should I see it?
>>>> 
>>>>> On 7. Feb 2018, at 19:39, Jeff Young <jeff@xxxxxxxxx> wrote:
>>>>> 
>>>>> The crosshairs should be available again in a current build.  Do you see the toolbar button on the left?
>>>>> 
>>>>>> On 7 Feb 2018, at 17:36, Bernhard Stegmaier <stegmaier@xxxxxxxxxxxxx> wrote:
>>>>>> 
>>>>>> … yes, no good.
>>>>>> It seems to be OK when just panning around.
>>>>>> But, it gets very laggy while e.g. dragging/moving symbols around (even on a not so big schematic I had at hand).
>>>>>> 
>>>>>> It is fine if you take out the Refresh() quoted below on macOS.
>>>>>> I didn’t see any obvious things on a quick check with the remaining changes (might be due to the fact that crosshair is still disabled on macOS?).
>>>>>> 
>>>>>> 
>>>>>> Regards,
>>>>>> Bernhard
>>>>>> 
>> 
>> 
> 
> _______________________________________________
> Mailing list: https://launchpad.net/~kicad-developers
> Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~kicad-developers
> More help   : https://help.launchpad.net/ListHelp