kicad-developers team mailing list archive

[Jeff Young <jeff@xxxxxxxxx>]

Hi Seth,

We’re not adding that curve; it’s in the Eagle file:

<polygon width="0.1524" layer="1" spacing="0.6096" isolate="0.3048" rank="2">
<vertex x="102.108" y="53.848"/>
<vertex x="102.108" y="-0.508"/>
<vertex x="-1.016" y="-0.508"/>
<vertex x="-1.016" y="52.832" curve="-89.13168"/>
<vertex x="0" y="53.848"/>
</polygon>


> On 16 Jul 2019, at 13:43, Seth Hillbrand <seth@xxxxxxxxxxxxx> wrote:
> 
> Hi Jeff-
> 
> That one was the Due reference design [1] but for me it happens on all Eagle zones.
> 
> -Seth
> 
> [1] https://content.arduino.cc/assets/DUE-reference.zip
> 
> On 2019-07-16 08:16, Jeff Young wrote:
>> Hi Seth,
>> I’m not seeing the same behaviour.  Could you send me the Eagle file
>> you were using for that screen-shot?
>> Thanks,
>> Jeff.
>>> On 16 Jul 2019, at 12:47, Jeff Young <jeff@xxxxxxxxx> wrote:
>>> Actually, something fishy is going on with the MiterLimit.  It
>>> should be rounding the fill, but not the outline (even in strategy
>>> (a))….
>>> On 16 Jul 2019, at 10:12, Jeff Young <jeff@xxxxxxxxx> wrote:
>>> We need to go to strategy (b) to fix that (use the zone’s fillet
>>> radius to round the corners).
>>> I’ll look into it….
>>> On 16 Jul 2019, at 02:37, Seth Hillbrand <seth@xxxxxxxxxxxxx> wrote:
>>> Hi Jeff-
>>> I just checked a couple of Eagle boards and the imports are now
>>> slightly problematic.  See the attached image.  This corner is
>>> square in Eagle.  It can be very difficult to edit zones with a
>>> bunch of extra points, so I'd like to avoid this if possible.
>>> Best-
>>> Seth
>> _______________________________________________
>> Mailing list: https://launchpad.net/~kicad-developers
>> Post to     : kicad-developers@xxxxxxxxxxxxxxxxxxx
>> Unsubscribe : https://launchpad.net/~kicad-developers
>> More help   : https://help.launchpad.net/ListHelp