mythbuntu-bugs team mailing list archive

[David Mitchell <launchpad.admin@xxxxxxxxxxxxxx>]

Not sure if it is relevant or not...
After a reboot mythtv cannot tune any channels and femon doesn't show a 'locked' message UNTIL I run a scan (after stopping mythtv-backend...). Femon shows 'locked' during the scan and channels are found & the locked message persists after the scan finishes (or I kill it with ctl-c!) and mythtv will then tune channels.  Possible difference in card initialisation ?

HOWEVER I have just updated to 23.1 and now cannot get myth to lock, am
doing a full remove/distclean/make/install to see if it fixes the
problem...

David

-- 
HVR-1300 HVR-3000 HVR-4000 broken in kernel
https://bugs.launchpad.net/bugs/439163
You received this bug notification because you are a member of Mythbuntu
Bug Team, which is subscribed to Mythbuntu.

Status in Mythbuntu, Ubuntu derivative focused upon MythTV: Triaged
Status in MythTV: Invalid
Status in “linux” package in Ubuntu: Triaged

Bug description:
This is a continuation of bug #436564. Please refer to that for relevant dmesg'.
The capture card I have is the Hauppauge HVR-1300.
The card is now correctly recognized as DVB-T but channel scan fails with message "Timed out, no signal" at each channel is scanned.
The command scan <location> > channels.conf ends correcly and file channels.conf is feeded with all tunable channels.
I tried to import such channels.conf with the same result.
Increasing the signal and channel timeout in the DVB settings (now up to 1000 but I planned to increase to ignore) doesnt solve the problem.
Tonight I will try what Marc suggested - mythtv-setup --verbose channelscan,siparser,channel,record - then I will report the log.