← Back to team overview

openstack team mailing list archive

Re: grizzly keystone with v1.0 API

 

Thank you Matthieu,


that sounds very interesting. The grizzly i am using comes with an "all
in one keystone.conf". I think that is fine and should work.

Would you be so kind and send me your "/etc/keystone/keystone.conf" and
"/etc/keystone/keystone-paste.ini". I would like to compare these to
mine and hope it brings me a lot closer.


Yes, thats what i ment on the zmanda-blog.


Thnak you!


Axel



Am 05.06.13 11:30, schrieb Matthieu Huin:
> Hello Axel,
> 
> If you refer to this post : http://www.zmanda.com/blogs/?p=1002 , I managed to set it up successfully on a devstack ( that's the trunk version, though, not grizzly ). There is a mistake in the instructions; the config file to modify is not /etc/keystone/keystone.conf but /etc/keystone/keystone-paste.ini .
> 
> Hope that helps.
> 
> Matthieu Huin 
> 
> mhu@xxxxxxxxxxxx
> 
> ----- Original Message -----
> From: "Axel Christiansen" <axel.christiansen@xxxxxxxxxxxx>
> To: openstack@xxxxxxxxxxxxxxxxxxx
> Sent: Wednesday, June 5, 2013 11:23:13 AM
> Subject: [Openstack] grizzly keystone with v1.0 API
> 
> Hello List again,
> 
> 
> on the zmanda-blog is a description to make a swift/keystone setup work
> again via the v1.0 API. Had anyone success doing this on grizzly?
> 
> I sadly did not.
> 
> 
> Regards, Axel
> 
> _______________________________________________
> Mailing list: https://launchpad.net/~openstack
> Post to     : openstack@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~openstack
> More help   : https://help.launchpad.net/ListHelp
> 



Follow ups

References