sslug-teknik team mailing list archive

[Ole Kofoed Hansen <k01164@xxxxxxxxx>]

Der er flere, som har spurgt om hvordan man får lyden
til at virke med at opl3sax kort. På SuSE-listen fik
jeg fornyligt dette, som fik det til at virke for mig.
Ihvertfald dytter og båtter Enlightenment af mig nu. :-)

Hvis insmod opl3sa2.... giver en device or resource busy
fejl, er det sandsynligvis fordi BIOS er sat til PnP-OS.

Bemærk også, at boot.local filen muligvis ligger et andet
sted og/eller hedder noget andet i andre distributioner.

Regards    Med venlig hilsen

  Ole Kofoed Hansen

mailto:k01164@xxxxxxxxx
ICQ-UIN: 25773325


On Tue, 23 Mar 1999, Danny Kephart wrote:
> Eric,
> 
> You're in luck. I have the same running. I messed around with it for awhile
> until I read a little page setup by the guy who wrote the yamaha driver.
> Following those directions, I came up with this. It does work.
> 
> With kernel 2.2.3:
> 
> <*> OSS sound modules
>         <M> 100% Sound Blaster compatibles (SB16/32/64, ESS, Jazz16) support
>         <M> Generic OPL2/OPL3 FM synthesizer support
>         <M> Microsoft Sound System support
>         <M> Support for Yamaha OPL3-SA2, SA3, and SAx based PnP cards
>         <M> SoftOSS software wave table engine
>         <M> FM synthesizer (YM3812/OPL-3) support
>         <M> Loopback MIDI device suppor
> then:
> 
> insmod mpu401
> insmod ad1848 irq=11
> insmod opl3sa2 io=0x370 mss_io=0x530 irq=5 dma=0 dma2=3
> insmod opl3 io=0x388
> 
> You can also put these it /sbin/init.d/boot.local/  and have them load
> on boot.
> 
> **HINT**: turn the BIOS "PNP OS" option "OFF". This makes all the difference
> in the world.