sslug-teknik team mailing list archive

[henrik@xxxxxxx (Henrik St�)]

In <20010516122320.A490@xxxxxxxxxxx> "Jesper P. Krogh" <jesper@xxxxxxxxxxx> writes:

>Hvordan får jeg min dhcp daemon til kun at broadcaste på mit eth0 interface..
>Hvis jeg undlader at skrive eth1 i min dhcpd.conf brokker daemonen sig over
>at der er et subnet som ikke står i dhcpd.conf..

Du starter dhcpd processen med "dhcpd eth0", sådan som der står
i man-siden:


COMMAND LINE

The names of the network interfaces on which dhcpd should listen for
broadcasts may be specified on the command line.  This should be done
on systems where dhcpd is unable to identify non-broadcast interfaces,
but should not be required on other systems.  If no interface names
are specified on the command line dhcpd will identify all network
interfaces which are up, elimininating non-broadcast interfaces if
possible, and listen for DHCP broadcasts on each interface.


Henrik
-- 
Henrik Storner      | "ATA100 is another testimony to the fact that 
<henrik@xxxxxxxxxx> |  pigs can be made to fly given sufficient thrust"
                    | 
                    |          Linux kernel hacker Alan Cox, on IDE drives