sslug-teknik team mailing list archive

[Jon Svejgaard <jon@xxxxxx>]

Jesper Krogh wrote:
> I sslug.teknik, skrev Jon Svejgaard:
>
> > Jesper Krogh wrote:
> >
> > > Nu sidder jeg lige en en almindelig tty, hvordan sætter jeg
> > > enentligt opløsningen på denne?
> > >
> > > På min 19" skærm er hver tegn ca 5x10mm hvert. Det er da
> > > til at se men ikke særligt effektivt, så jeg ville gerne 
> > > sætte den op. 
> >
> > Sakset fra min /etc/X11/XF86Config for framebuffer:
> >
> > # To get the kernel to start in VESA framebuffer mode, you need to pass it
> > # a vga= init string at boot time.  For example, if you use LILO you'll
> > # probably find a vga=normal string in your /etc/lilo.conf.  If you edit 
> > that
> > # to one of the values in this table:
> > #
> > #   Colours   640x480 800x600 1024x768 1280x1024 1600x1200
> > #  --------+---------------------------------------------
> > #  256     |   769     771      773      775       796
> > #  32,768  |   784     787      790      793       797
> > #  65,536  |   785     788      791      794       798
> > #  16.8M   |   786     789      792      795       799
> > #
> > #  ...such as this for 1024x768x64k:
> > #  vga = 791
> > #  and then reinstall LILO by running 'lilo' as root, then at the next boot
> > #  Linux should start in a VESA framebuffer console mode.
>
>
> Kanont, mange tak. Det pyntede virkeligt.
"One is always glad to be of service"
		- Isaac Asimov, The Bicentennial Man
MVH
--
Jon Svejgaard
====================================================================
                               | ACE - UNIX/Linux Consultancy
                               | Hjorthoejvej 2 / DK-4291 Ruds Vedby
mail: jon@xxxxxx               | DENMARK
http://www.ace.dk              | +45 5826 1799 / +45 4052 0799
====================================================================