sslug-teknik team mailing list archive

[Klavs Klavsen <kl@xxxxxxx>]

Når jeg brænder med cdrecord fra kommando linien sådan her:

cdrecord  -v -mode2 -dao dev=0,4,0 speed=4  /backup/image.iso

(det samme sker hvis jeg prøver -xa2 istedet).

får jeg:
Cdrecord 1.11a39 (i686-pc-linux-gnu) Copyright (C) 1995-2002 Jörg
Schilling TOC Type: 1 = CD-ROM
scsidev: '0,4,0'
scsibus: 0 target: 4 lun: 0
Linux sg driver version: 3.1.24
Using libscg version 'schily-0.7'
atapi: 0
Device type    : Removable CD-ROM
Version        : 2
Response Format: 2
Capabilities   : SYNC LINKED
Vendor_info    : 'PLEXTOR '
Identifikation : 'CD-R   PX-R412C '
Revision       : '1.06'
Device seems to be: Generic mmc CD-R.
Using generic SCSI-3/mmc CD-R driver (mmc_cdr).
Driver flags   : MMC SWABAUDIO
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P
RAW/R96R Drive buf size : 1168944 = 1141 KB
FIFO size      : 4194304 = 4096 KB
Track 01: data   699 MB
Total size:      704 MB (69:48.09) = 314107 sectors
Lout start:      704 MB (69:50/07) = 314107 sectors
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 4
  Is unrestricted
  Is not erasable
  ATIP start of lead in:  -11077 (97:34/23)
  ATIP start of lead out: 359849 (79:59/74)
Disk type:    Long strategy type (Cyanine, AZO or similar)
Manuf. index: 11
Manufacturer: Mitsubishi Chemical Corporation
Blocks total: 359849 Blocks current: 359666 Blocks remaining: 45559
Starting to write CD/DVD at speed 4 in real SAO mode for single session.
Last chance to quit, starting real write    0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Sending CUE sheet...
Writing pregap for track 1 at 33
cdrecord: Input/output error. write_g1: scsi sendcmd: no error
CDB:  2A 00 00 00 00 21 00 00 1B 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 24 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x24 Qual 0x00 (invalid field in cdb) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 63072
cmd finished after 0.073s timeout 200s
write track pad data: error after 0 bytes
BFree: 1141 K BSize: 1141 K
Starting new track at sector: 183
Track 01:    0 of  699 MB written.cdrecord: Input/output error.
write_g1: scsi sendcmd: no error CDB:  2A 00 00 00 00 B7 00 00 1B 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 24 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x24 Qual 0x00 (invalid field in cdb) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 63072
cmd finished after 0.002s timeout 200s

write track data: error after 0 bytes
^MSense Bytes: 70 00 00 00 00 00 00 0A 00 00 00 00 00 00 00 00 00 00
Writing  time:   15.073s
Average write speed 824.4x.
Fixating...
Fixating time:    0.002s
cdrecord: fifo had 64 puts and 1 gets.
cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.


-- 
Regards,
Klavs Klavsen

--------------| This mail has been sent to you by: |------------
              Klavs Klavsen - Open Source Consultant 
            klavs@xxxxxxxxxxx - http://www.EnableIT.dk

    Get PGP key from www.keyserver.net - Key ID: 0x586D5BCA 
Fingerprint = 2873 188C 968E 600D D8F8  B8DA 3D3A 0B79 7E06 3C62
----------------------------------------------------------------
Open Source Software - Sometimes you get more than you paid for.
						 -- unknown