sslug-teknik team mailing list archive
-
sslug-teknik team
-
Mailing list archive
-
Message #78758
RE: Kortere opstartstid
> Kan du ikke vise hvad "hdparm -t -T -i -I /dev/hda" viser på
> din maskine (jeg går ud fra du kun har den ene disk)?
Her er hvad den viser:
pc-00023:~ # hdparm -t -T -i -I /dev/hda
/dev/hda:
Model=IC25N040ATMR04-0, FwRev=MO2OAD4A, SerialNo=MRG205KBGLGTAH Config={
HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs } RawCHS=16383/16/63,
TrkSize=0, SectSize=0, ECCbytes=4 BuffType=DualPortCache, BuffSize=1740kB,
MaxMultSect=16, MultSect=16 CurCHS=16383/16/63, CurSects=16514064, LBA=yes,
LBAsects=72125429 IORDY=on/off, tPIO={min:240,w/IORDY:120},
tDMA={min:120,rec:120} PIO modes: pio0 pio1 pio2 pio3 pio4 DMA modes:
mdma0 mdma1 mdma2 UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5
AdvancedPM=yes: mode=0x80 (128) WriteCache=enabled Drive conforms to:
ATA/ATAPI-6 T13 1410D revision 3a:
* signifies the current active mode
ATA device, with non-removable media
Model Number: IC25N040ATMR04-0
Serial Number: MRG205KBGLGTAH
Firmware Revision: MO2OAD4A
Standards:
Used: ATA/ATAPI-6 T13 1410D revision 3a
Supported: 6 5 4 3
Configuration:
Logical max current
cylinders 16383 16383
heads 16 16
sectors/track 63 63
--
CHS current addressable sectors: 16514064
LBA user addressable sectors: 78140160
device size with M = 1024*1024: 38154 MBytes
device size with M = 1000*1000: 40007 MBytes (40 GB)
Capabilities:
LBA, IORDY(can be disabled)
bytes avail on r/w long: 4 Queue depth: 1
Standby timer values: spec'd by Vendor, no device specific minimum
R/W multiple sector transfer: Max = 16 Current = 16
Advanced power management level: 128 (0x80)
Recommended acoustic management value: 128, current value: 254
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* NOP cmd
* READ BUFFER cmd
* WRITE BUFFER cmd
* Host Protected Area feature set
* Look-ahead
* Write cache
* Power Management feature set
Security Mode feature set
* SMART feature set
* Mandatory FLUSH CACHE command
* Device Configuration Overlay feature set
Automatic Acoustic Management feature set
SET MAX security extension
Address Offset Reserved Area Boot
* SET FEATURES subcommand required to spinup after power up
Power-Up In Standby feature set
* Advanced Power Management feature set
* SMART self-test
* SMART error logging
Security:
Master password revision code = 65534
supported
not enabled
not locked
frozen
not expired: security count
not supported: enhanced erase
34min for SECURITY ERASE UNIT.
HW reset results:
CBLID- above Vih
Device num = 0 determined by the jumper
Checksum: correct
Timing cached reads: 464 MB in 2.00 seconds = 231.92 MB/sec
Timing buffered disk reads: 58 MB in 3.06 seconds = 18.93 MB/sec
References