sslug-teknik team mailing list archive

[Kristian Kallenberg <kale@xxxxxxxxxxxxx>]

> > Er her nogen som har fået tunerdelen til at fungere i ovenstående kort...
> og
> > hvordan?
>
> Jeg går ud fra at du anvender ivtv driveren.
>
> Til denne følger der et par utilities til at håndtere tuneren.
> Prøv evt. ptune-ui (fra util kataloget).
> Du kan her vælge, hvilken kanal (og en masse andet som for
> eksempel videostandard og frekvenser).
>
> Hvis dette ikke er tilstrækkeligt må du lige fortælle noget
> om hvordan du vælger DR1:

ivtvctl -p 4
ivtvctl -u 0xff
ivtvctl -f width=720,height=576
ivtvctl -v input=3,output=1
ptune.pl --freqtable pal-europe -c 31

> og hvordan du ellers har konfigureret
> driveren:

(/etc/modules.d/ivtv):
alias char-major-81     videodev
alias char-major-81-0   ivtv
alias char-major-61 lirc_i2c
options ivtv debug=1 ivtv_std=2
options msp3400 once=1 simple=1
add below ivtv msp3400 saa7115 tuner
add above ivtv lirc_dev lirc_i2c

>(og hvad siger dmesg om initialiseringen af kortet?):

ivtv: ==================== START INIT IVTV ====================
ivtv: version 0.2.0 (rc3j) loading
ivtv: Linux version: 2.6.10 preempt VIAC3-2 gcc-3.3
ivtv: In case of problems please include the debug info
ivtv: between the START INIT IVTV and END INIT IVTV lines when
ivtv: mailing the ivtv-devel mailinglist.
ivtv: Autodetected WinTV PVR 350 card
ivtv: Found an iTVC15 based chip
ACPI: PCI interrupt 0000:00:14.0[A] -> GSI 11 (level, low) -> IRQ 11
ivtv: VIA PCI device: 0x0259 vendor: 0x1106
saa7127: detecting saa7127 client on address 0x88
saa7127: Selecting NTSC video Standard
saa7127: Selecting S-Video+Composite
saa7127: Turn WSS off
saa7127: Widescreen Mode 4:3 Full Format
saa7127: Selecting Normal Encoder Input
saa7127: Enable Video Output
ivtv: i2c attach [client=saa7127,ok]
msp34xx: ivtv version
msp34xx: init: chip=MSP3418W-B3, has NICAM support, simple (D) mode, simpler (G)
no-thread mode
msp34xx: $Id$ compiled on: Jun 27 2005 16:22:49
ivtv: i2c attach [client=MSP3418W-B3,ok]
saa7115: starting probe for adapter ivtv i2c driver #0 (0x10005)
saa7115: detecting saa7115 client on address 0x42
saa7115: writing init values
ivtv: i2c attach [client=saa7115,ok]
saa7115: status: (1E) 0x40, (1F) 0xc0
tuner: chip found at addr 0xc2 i2c-bus ivtv i2c driver #0
ivtv: i2c attach [client=(tuner unset),ok]
tveeprom: Hauppauge: model = 48139, rev = K257, serial# = 7979615
tveeprom: tuner = Philips FM1216 ME MK3 (idx = 57, type = 38)
tveeprom: tuner fmt = PAL(D/K) (eeprom = 0x74, v4l2 = 0x00400e17)
tveeprom: audio_processor = CS5331 (type = 9)
ivtv: i2c attach [client=tveeprom,ok]
ivtv: Tuner Type 38, Tuner formats 0x00400e17, Radio: yes, Model 0x00ad2557,
Revision 0x00000001
ivtv: PAL tuner detected
ivtv: SECAM tuner detected
ivtv: Radio detected
ivtv: Encoder revision: 0x02040024
ivtv: Encoder Firmware may be buggy, use version 0x02040011
ivtv: Decoder revision: 0x02020023
ivtv: Configuring WinTV PVR 350 card with 9 streams
ivtv: Create DMA stream 0 using 256 16384 byte buffers  4194304 kbytes total
ivtv: Registered v4l2 device, streamtype 0 minor 0
ivtv: Create DMA stream 1
ivtv: Registered v4l2 device, streamtype 1 minor 32
ivtv: Create stream 2 using 40 52224 byte buffers  2097152 kbytes total
ivtv: Registered v4l2 device, streamtype 2 minor 224
ivtv: Create DMA stream 3 using 455 4608 byte buffers  2097152 kbytes total
ivtv: Registered v4l2 device, streamtype 3 minor 24
ivtv: Create stream 4
ivtv: Registered v4l2 device, streamtype 4 minor 64
ivtv: Create DMA stream 5 using 16 65536 byte buffers  1048576 kbytes total
ivtv: Registered v4l2 device, streamtype 5 minor 16
ivtv: Create stream 6 using 1024 2048 byte buffers  262144 kbytes total
ivtv: Registered v4l2 device, streamtype 6 minor 228
ivtv: Create stream 7
ivtv: Registered v4l2 device, streamtype 7 minor 232
ivtv: Create DMA stream 8
ivtv: Registered v4l2 device, streamtype 8 minor 48
ivtv: Setting Tuner 38
tuner: type set to 38 (Philips PAL/SECAM multi (FM1216ME MK3)) by ivtv i2c
driver #0
saa7115: decoder set input (4)
saa7115: now setting Composite input
ivtv: ivtv_enc_thread: pid = 10301, itv = 0xdcbba620
ivtv: ivtv_dec_thread: pid = 10302, itv = 0xdcbba620
ivtv: Setting audio matrix to input 3, output 1
ivtv: Switching standard to PAL.
spurious 8259A interrupt: IRQ7.
saa7115: decoder set norm PAL
saa7115: set audio: 0x01
saa7127: Setting Encoder Video Standard
saa7127: Set PAL Video Mode
saa7127: Selecting PAL video Standard
ivtv: Initialized WinTV PVR 350, card #0
ivtv: ====================  END INIT IVTV  ====================

/kallenberg