sslug-teknik team mailing list archive
-
sslug-teknik team
-
Mailing list archive
-
Message #83509
Re: Servernedbrud
Christian Iversen wrote:
> Mon ikke du har haft en harddiskfejl, med korruption af kernen til følge?
Jeg har installeret smart, her kommer outputtet, som indeholder flere fejl!
Jeg har bare ikke kendskab nok til at blive klog på om det er en fejl der er
alvorlig nok til at kernen kan gå i panic?
Bør jeg fare ud om købe en ny disk?
Det er omkring en uge siden jeg omformaterte hda7 og insatllerte Mandrake på
den.
Hvad kan jeg ellers bruge til at teste disken med?
,----[ ]
| [ivar@milli ivar]$ sudo smartctl /dev/hda -a
| smartctl version 5.32 Copyright (C) 2002-4 Bruce Allen
| Home page is http://smartmontools.sourceforge.net/
|
| === START OF INFORMATION SECTION ===
| Device Model: Maxtor 2B020H1
| Serial Number: B1H0YLPE
| Firmware Version: WAH21PB0
| Device is: In smartctl database [for details use: -P show]
| ATA Version is: 6
| ATA Standard is: ATA/ATAPI-6 T13 1410D revision 0
| Local Time is: Wed Jul 13 16:57:33 2005 CEST
| SMART support is: Available - device has SMART capability.
| SMART support is: Enabled
|
| === START OF READ SMART DATA SECTION ===
| SMART overall-health self-assessment test result: PASSED
|
| General SMART Values:
| Offline data collection status: (0x85) Offline data collection activity
| was aborted by an interrupting
command from host.
| Auto Offline Data Collection:
Enabled.
| Self-test execution status: ( 0) The previous self-test routine
completed
| without error or no self-test has
ever
| been run.
| Total time to complete Offline
| data collection: ( 781) seconds.
| Offline data collection
| capabilities: (0x1b) SMART execute Offline immediate.
| Auto Offline data collection
on/off support.
| Suspend Offline collection upon
new
| command.
| Offline surface scan supported.
| Self-test supported.
| No Conveyance Self-test supported.
| No Selective Self-test supported.
| SMART capabilities: (0x0003) Saves SMART data before entering
| power-saving mode.
| Supports SMART auto save timer.
| Error logging capability: (0x01) Error logging supported.
| No General Purpose Logging
support.
| Short self-test routine
| recommended polling time: ( 2) minutes.
| Extended self-test routine
| recommended polling time: ( 13) minutes.
|
| SMART Attributes Data Structure revision number: 16
| Vendor Specific SMART Attributes with Thresholds:
| ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED
WHEN_FAILED RAW_VA
| LUE
| 3 Spin_Up_Time 0x0027 235 232 063 Pre-fail Always
- 6291
| 4 Start_Stop_Count 0x0032 252 252 000 Old_age Always
- 2534
| 5 Reallocated_Sector_Ct 0x0033 252 252 063 Pre-fail Always
- 3
| 6 Read_Channel_Margin 0x0001 253 253 100 Pre-fail Offline
- 0
| 7 Seek_Error_Rate 0x000a 253 252 000 Old_age Always
- 0
| 8 Seek_Time_Performance 0x0027 250 233 187 Pre-fail Always
- 45588
| 9 Power_On_Minutes 0x0032 250 250 000 Old_age Always
- 286h+1
| 1m
| 10 Spin_Retry_Count 0x002b 253 252 223 Pre-fail Always
- 0
| 11 Calibration_Retry_Count 0x002b 253 252 223 Pre-fail Always
- 0
| 12 Power_Cycle_Count 0x0032 251 251 000 Old_age Always
- 963
| 192 Power-Off_Retract_Count 0x0032 253 253 000 Old_age Always
- 274
| 193 Load_Cycle_Count 0x0032 252 252 000 Old_age Always
- 4542
| 194 Unknown_Attribute 0x0032 253 253 000 Old_age Always
- 0
| 195 Hardware_ECC_Recovered 0x000a 253 252 000 Old_age Always
- 498
| 196 Reallocated_Event_Count 0x0008 253 253 000 Old_age Offline
- 0
| 197 Current_Pending_Sector 0x0008 253 253 000 Old_age Offline
- 0
| 198 Offline_Uncorrectable 0x0008 253 253 000 Old_age Offline
- 0
| 199 UDMA_CRC_Error_Count 0x0008 199 197 000 Old_age Offline
- 3
| 200 Multi_Zone_Error_Rate 0x000a 253 252 000 Old_age Always
- 0
| 201 Soft_Read_Error_Rate 0x000a 253 252 000 Old_age Always
- 7
| 202 TA_Increase_Count 0x000a 253 252 000 Old_age Always
- 0
| 203 Run_Out_Cancel 0x000b 253 252 180 Pre-fail Always
- 0
| 204 Shock_Count_Write_Opern 0x000a 253 252 000 Old_age Always
- 0
| 205 Shock_Rate_Write_Opern 0x000a 253 252 000 Old_age Always
- 0
| 207 Spin_High_Current 0x002a 253 252 000 Old_age Always
- 0
| 208 Spin_Buzz 0x002a 253 252 000 Old_age Always
- 0
| 209 Offline_Seek_Performnce 0x0024 190 189 000 Old_age Offline
- 0
| 99 Unknown_Attribute 0x0004 253 253 000 Old_age Offline
- 0
| 100 Unknown_Attribute 0x0004 253 253 000 Old_age Offline
- 0
| 101 Unknown_Attribute 0x0004 253 253 000 Old_age Offline
- 0
|
| SMART Error Log Version: 1
| Warning: ATA error count 857 inconsistent with error log pointer 5
|
| ATA Error Count: 857 (device log contains only the most recent five
errors)
| CR = Command Register [HEX]
| FR = Features Register [HEX]
| SC = Sector Count Register [HEX]
| SN = Sector Number Register [HEX]
| CL = Cylinder Low Register [HEX]
| CH = Cylinder High Register [HEX]
| DH = Device/Head Register [HEX]
| DC = Device Command Register [HEX]
| ER = Error register [HEX]
| ST = Status register [HEX]
| Powered_Up_Time is measured from power on, and printed as
| DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
| SS=sec, and sss=millisec. It "wraps" after 49.710 days.
|
| Error 857 occurred at disk power-on lifetime: 1279 hours (53 days + 7
hours)
| When the command that caused the error occurred, the device was in an
unknown state.
|
| After command completion occurred, registers were:
| ER ST SC SN CL CH DH
| -- -- -- -- -- -- --
| 04 51 00 3f 00 00 a0
|
| Commands leading to the command that caused the error were:
| CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
| -- -- -- -- -- -- -- -- ---------------- --------------------
| 08 00 00 3f 00 00 a0 00 1d+03:10:24.528 DEVICE RESET
| c8 ff 01 3f 00 00 e0 00 1d+03:10:24.528 READ DMA
| c8 ff 01 1b c8 d2 e0 00 1d+03:10:24.528 READ DMA
| c8 ff 01 1a c8 d2 e0 00 1d+03:10:24.528 READ DMA
| c8 ff 01 19 c8 d2 e0 00 1d+03:10:24.528 READ DMA
|
| Error 856 occurred at disk power-on lifetime: 1279 hours (53 days + 7
hours)
| When the command that caused the error occurred, the device was in an
unknown state.
|
| After command completion occurred, registers were:
| ER ST SC SN CL CH DH
| -- -- -- -- -- -- --
| 04 51 00 00 00 00 a0 Error: ABRT
|
| Commands leading to the command that caused the error were:
| CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
| -- -- -- -- -- -- -- -- ---------------- --------------------
| a1 00 00 00 00 00 a0 00 1d+02:50:37.968 IDENTIFY PACKET DEVICE
| ca 00 08 a7 11 40 e0 00 1d+02:50:35.392 WRITE DMA
| ca 00 08 97 11 40 e0 00 1d+02:50:30.928 WRITE DMA
| ca 00 08 cf 6a 18 e0 00 1d+02:50:30.928 WRITE DMA
| ca 00 08 97 11 40 e0 00 1d+02:50:30.928 WRITE DMA
|
| Error 855 occurred at disk power-on lifetime: 1279 hours (53 days + 7
hours)
| When the command that caused the error occurred, the device was in an
unknown state.
|
| After command completion occurred, registers were:
| ER ST SC SN CL CH DH
| -- -- -- -- -- -- --
| 04 51 00 00 00 00 a0 Error: ABRT
|
| Commands leading to the command that caused the error were:
| CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
| -- -- -- -- -- -- -- -- ---------------- --------------------
| a1 00 00 00 00 00 a0 00 1d+02:43:21.280 IDENTIFY PACKET DEVICE
| ca ff 01 e7 38 aa e0 00 1d+02:43:17.904 WRITE DMA
| c8 ff 01 e7 38 aa e0 00 1d+02:43:17.904 READ DMA
| c8 ff 01 e7 38 aa e0 00 1d+02:43:17.888 READ DMA
| ca ff 01 e7 38 aa e0 00 1d+02:43:17.888 WRITE DMA
|
| Error 854 occurred at disk power-on lifetime: 1279 hours (53 days + 7
hours)
| When the command that caused the error occurred, the device was in an
unknown state.
|
| After command completion occurred, registers were:
| ER ST SC SN CL CH DH
| -- -- -- -- -- -- --
| 04 51 00 3f 00 00 a0
|
| Commands leading to the command that caused the error were:
| CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
| -- -- -- -- -- -- -- -- ---------------- --------------------
| 08 00 00 3f 00 00 a0 00 1d+02:43:13.232 DEVICE RESET
| c8 ff 01 3f 00 00 e0 00 1d+02:43:13.232 READ DMA
| c8 ff 01 1b c8 d2 e0 00 1d+02:43:13.232 READ DMA
| c8 ff 01 1a c8 d2 e0 00 1d+02:43:13.232 READ DMA
| c8 ff 01 19 c8 d2 e0 00 1d+02:43:13.232 READ DMA
|
| Error 853 occurred at disk power-on lifetime: 1279 hours (53 days + 7
hours)
| When the command that caused the error occurred, the device was in an
unknown state.
|
| After command completion occurred, registers were:
| ER ST SC SN CL CH DH
| -- -- -- -- -- -- --
| 04 51 00 00 00 00 a0 Error: ABRT
|
| Commands leading to the command that caused the error were:
| CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
| -- -- -- -- -- -- -- -- ---------------- --------------------
| a1 00 00 00 00 00 a0 00 1d+02:32:54.800 IDENTIFY PACKET DEVICE
| c8 ff 01 01 00 00 e0 00 1d+02:32:51.264 READ DMA
| c8 ff 01 00 00 00 e0 00 1d+02:32:51.264 READ DMA
| c8 ff 01 01 00 00 e0 00 1d+02:30:28.064 READ DMA
| c8 ff 01 2f 18 b8 e0 00 1d+02:30:28.064 READ DMA
|
| SMART Self-test log structure revision number 1
| Num Test_Description Status Remaining
LifeTime(hours) LBA_of_first_err or
| # 1 Extended offline Completed without error 00% 1243
-
| # 2 Extended offline Completed without error 00% 1243
-
| # 3 Extended offline Completed without error 00% 1242
-
| # 4 Extended offline Completed without error 00% 1242
-
|
| Device does not support Selective Self Tests/Logging
`----
--
Med venlig hilsen
Ivar Madsen
Hjælp til med at få overblik over CC's ADSL priser på
http://milli.dk/index.php/CC_ADSL_priser
--------------------------------------------------------------------------------
Follow ups
References
