sslug-teknik team mailing list archive

["Mogens Melander" <mogens@xxxxxxxxxxxxx>]

Hej,

Jeg har fæle problemer med et par gigabit netkort i en server.

Kortene er Broadcom Trigon 3 (BCM95721) rev 4101.

Switchen den er tilsluttet kører ikke autonegotiate, og jeg kan ikke
andre kortenes setup med ethtool. Planen var at sætte speed 1000,
duplex full og autoneg off med forskellige varianter af kommandoen:

# ethtool -s eth0 speed 1000 duplex full autoneg off
Cannot set new settings: Invalid argument
  not setting speed
  not setting duplex
  not setting autoneg

Google fortæller at jeg er langt fra den eneste med samme problem,
men ingen synes at have løsningen. Nogen hints til hvad den rette
kung-fu kunne være ?

# ethtool eth0
Settings for eth0:
        Supported ports: [ MII ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Half 1000baseT/Full
        Advertised auto-negotiation: Yes
        Speed: 1000Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 1
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: g
        Wake-on: d
        Current message level: 0x000000ff (255)
        Link detected: yes

-- 
Later

Mogens Melander
+45 40 85 71 38
+66 870 133 224



-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.