sslug-teknik team mailing list archive

["Tommy Nikolajsen (oz1cys)" <naturgrise@xxxxxxxxxxxxx>]

Ma*ske dette link kan hj?lpe dig?

http://forums.whirlpool.net.au/forum-replies.cfm?t=1044617&p=16#r309

Enheden skal tilsyneladende skiftes fra "disk" emulering til "modem"
emulering via en kommando over usb'en (program kan findes via link til at
k?re dette).

Mvh
Jesper K. Pedersen

Siden som henvises til er helt sikkert den rigtige til at l?se problemet.
Men det er desv?rre stadig ikke lykkedes mig at fa* kontakt til 
omverdenen via modemet.
Her er lidt info.


brugte kommandoen
sudo make integrated_install
ved installation af
usb_modeswitch-1.0.5.tar.bz2
ma*ske en fejlkilde



modprobe usbserial vendor=0x19d2 usbserial product=0x0031

Giver f?lgende resultat:

d@d-laptop:~$ sudo modprobe usbserial vendor=0x19d2 usbserial product=0x0031
[sudo] password for d:
FATAL: Error inserting usbserial 
(/lib/modules/2.6.28-15-generic/kernel/drivers/usb/serial/usbserial.ko): 
Unknown symbol in module, or unknown parameter (see dmesg)

og endnu en:

d@d-laptop:~$ sudo usb_modeswitch
[sudo] password for d:
* usb_modeswitch: tool for controlling "flip flop" mode USB devices
* Version 1.0.3 (C) Josua Dietze 2009
* Works with libusb 0.1.12 and probably other versions
Looking for target devices ...
No devices in target mode or class found
Looking for default devices ...
Found default devices (1)
Accessing device 002 on bus 002 ...
Using endpoints 0x01 (out) and 0x81 (in)
Inquiring device details; driver will be detached ...
Looking for active driver ...
OK, driver found ("usbfs")
OK, driver "usbfs" detached

running dmesg giver f?lgende (udrag):

[ 308.060488] usb 2-3: configuration #1 chosen from 1 choice
[ 308.068812] scsi8 : SCSI emulation for *USB Mass Storage devices*
[ 308.070040] usb-storage: device found at 4
[ 308.070046] usb-storage: waiting for device to settle before scanning
[ 313.068249] usb-storage: device scan complete
[ 313.075012] scsi 8:0:0:0: Direct-Access UDISK PDA05_1G 7BI2.0 8.00 PQ: 
0 ANSI: 2
[ 313.078953] sd 8:0:0:0: [sdc] 1968128 512-byte hardware sectors: (1.00 
GB/961 MiB)
[ 313.087470] sd 8:0:0:0: [sdc] Write Protect is off
[ 313.087478] sd 8:0:0:0: [sdc] Mode Sense: 03 00 00 00
[ 313.087483] sd 8:0:0:0: [sdc] Assuming drive cache: write through
[ 313.090064] sd 8:0:0:0: [sdc] 1968128 512-byte hardware sectors: (1.00 
GB/961 MiB)
[ 313.090572] sd 8:0:0:0: [sdc] Write Protect is off
[ 313.090577] sd 8:0:0:0: [sdc] Mode Sense: 03 00 00 00
[ 313.090582] sd 8:0:0:0: [sdc] Assuming drive cache: write through
[ 313.090593] sdc: sdc1
[ 313.093937] sd 8:0:0:0: [sdc] Attached SCSI removable disk
[ 313.094063] sd 8:0:0:0: Attached scsi generic sg3 type 0
[ 328.391096] usb 2-3: USB disconnect, address 4
[ 328.393858] Buffer I/O error on device sdc1, logical block 513
[ 328.393866] lost page write due to I/O error on sdc1
[ 328.393883] Buffer I/O error on device sdc1, logical block 959
[ 328.393888] lost page write due to I/O error on sdc1
[ 1171.828233] usbserial: Unknown parameter `usbserial'
[ 2662.744065] usb 2-3: new high speed USB device using ehci_hcd and 
address 5
[ 2662.944307] usb 2-3: configuration #1 chosen from 1 choice
[ 2662.946267] scsi9 : SCSI emulation for USB Mass Storage devices
[ 2662.946670] usb-storage: device found at 5
[ 2662.946674] usb-storage: waiting for device to settle before scanning
[ 2667.944343] usb-storage: device scan complete
[ 2667.950526] scsi 9:0:0:0: Direct-Access UDISK PDA05_1G 7BI2.0 8.00 
PQ: 0 ANSI: 2
[ 2667.957026] sd 9:0:0:0: [sdc] 1968128 512-byte hardware sectors: 
(1.00 GB/961 MiB)
[ 2667.968742] sd 9:0:0:0: [sdc] Write Protect is off
[ 2667.968750] sd 9:0:0:0: [sdc] Mode Sense: 03 00 00 00
[ 2667.968754] sd 9:0:0:0: [sdc] Assuming drive cache: write through
[ 2667.971129] sd 9:0:0:0: [sdc] 1968128 512-byte hardware sectors: 
(1.00 GB/961 MiB)
[ 2667.971620] sd 9:0:0:0: [sdc] Write Protect is off
[ 2667.971626] sd 9:0:0:0: [sdc] Mode Sense: 03 00 00 00
[ 2667.971631] sd 9:0:0:0: [sdc] Assuming drive cache: write through
[ 2667.971642] sdc: sdc1
[ 2667.974916] sd 9:0:0:0: [sdc] Attached SCSI removable disk
[ 2667.975046] sd 9:0:0:0: Attached scsi generic sg3 type 0
d@gd-laptop:~$

Det ser vel ud til at modemet ikke er registret som det skal??

d@d-laptop:~$ dmesg | tail
[ 2667.971129] sd 9:0:0:0: [sdc] 1968128 512-byte hardware sectors: 
(1.00 GB/961 MiB)
[ 2667.971620] sd 9:0:0:0: [sdc] Write Protect is off
[ 2667.971626] sd 9:0:0:0: [sdc] Mode Sense: 03 00 00 00
[ 2667.971631] sd 9:0:0:0: [sdc] Assuming drive cache: write through
[ 2667.971642] sdc: sdc1
[ 2667.974916] sd 9:0:0:0: [sdc] Attached SCSI removable disk
[ 2667.975046] sd 9:0:0:0: Attached scsi generic sg3 type 0
[ 3484.115638] usb 2-3: USB disconnect, address 5
[ 3484.118286] Buffer I/O error on device sdc1, logical block 513
[ 3484.118293] lost page write due to I/O error on sdc1
d@d-laptop:~

Ha*ber pa* at der en derude der vil hj?lpe med det sidste.

venlig hilsen og pa* forha*nd tak

Tommy Nikolajsen (oz1cys)