tiomap-dev team mailing list archive

Thread
Date

[Bug 1017438] Re: Panda: adb over usb broken on panda-ics-gcc47-tilt-tracking-blob/#build=101"

To: tiomap-dev@xxxxxxxxxxxxxxxxxxx
From: vishal <vishal.bhoj@xxxxxxxxxx>
Date: Mon, 23 Jul 2012 04:25:29 -0000
Reply-to: Bug 1017438 <1017438@xxxxxxxxxxxxxxxxxx>
Sender: bounces@xxxxxxxxxxxxx

Andy,

I am only  using this config to build against the kernel.Here is what I did:
1. Copied the config to arch/arm/configs.
2.  make ARCH=arm omap4plus_defconfig
3. make ARCH=arm menuconfig
4. Checked the configuration for "USB_MUSB_OMAP2PLUS" shown below.

 Symbol: USB_MUSB_OMAP2PLUS [=m]                                                                                                         │  
  │ Type  : tristate                                                                                                                        │  
  │ Prompt: OMAP2430 and onwards                                                                                                            │  
  │   Defined at drivers/usb/musb/Kconfig:49                                                                                                │  
  │   Depends on: <choice> && ARCH_OMAP2PLUS [=y]                                                                                           │  
  │   Location:                                                                                                                             │  
  │     -> Device Drivers                                                                                                                   │  
  │       -> USB support (USB_SUPPORT [=y])                                                                                                 │  
  │         -> Inventra Highspeed Dual Role Controller (TI, ADI, ...) (USB_MUSB_HDRC [=y])                                                  │  
  │           -> Platform Glue Layer (<choice> [=m])                                                                                        │  


The choice state for "Platform Glue Layer" is not reflecting the right configuration.

-- 
You received this bug notification because you are a member of TI OMAP
Developers, which is subscribed to linaro-landing-team-ti.
https://bugs.launchpad.net/bugs/1017438

Title:
  Panda: adb over usb broken on panda-ics-gcc47-tilt-tracking-
  blob/#build=101"

Status in Linaro Android:
  New
Status in Linaro Texas Instruments Landing Team:
  New

Bug description:
  Description:
  --------------
  adb over USB broken on :
  https://android-build.linaro.org/builds/~linaro-android/panda-ics-gcc47-tilt-tracking-blob/#build=101
  (Kernel version: 3.4)

  Steps:
  -------
  1. Bootup Android from sd card for above build
  2. Connect USB cable after device boots up
  3. type <path_to_android_sdk/platform-tools>adb devices     -on host machine. 
  Issue: No device listed. 

  I do not see USB detection messages on serial console when USB cable
  is connected to device.

To manage notifications about this bug go to:
https://bugs.launchpad.net/linaro-android/+bug/1017438/+subscriptions