yade-users team mailing list archive

[Ripudaman Manchanda <RManchanda@xxxxxxxxxxxxxxxxxxxxxxxx>]

Hi,
 
Thanks for confirming this. 
 
I tried getting the pdf, but I can't access it. I would be grateful if you
send me that document. 
 
Also, a part of my future problem is to flow fluid at different pressure
gradients through the desired geometry. I read your conference paper on a
similar issue but in 1D where you coupled YADE and OpenFOAM. I am not very
good at coding and this shall be my first time using LINUX. So can you just
describe to me how I can the effort be reduced in coding this stuff and if
there is an easier escape route now?
 
Thanks
 
Ripudaman Manchanda
Geomechanics Intern
Schlumberger DCS
1325 S. Dairy Ashford
Houston, TX 77077

  _____  

From: Chen, Feng [mailto:fchen3@xxxxxxx] 
Sent: Wednesday, June 17, 2009 9:17 AM
To: Ripudaman Manchanda; yade-users@xxxxxxxxxxxxxxxxxxx
Subject: RE: [Yade-users] Modifying the geometry of the wall?


Hi, Ripudaman:
 
According to your description, this model should be easily be modeled by
YADE, you can look at one of my previous publication:
 
Feng Chen, Eric. C. Drumm, Georges Guiochon, 3D DEM Analysis Of Graded Rock
Fill Sinkhole Repair: Particle Size Effects On The Probability Of Stability,
2009 Transportation Research Board Conference 
 
I can email you a pdf if you cannot find it.
Feng Chen

Geotechnical Engineer

HNTB Federal

9100 Bluebonnet Centre Blvd Suite 301

Baton Rouge, LA 70809

http://fchen3.googlepages.com/home

  _____  

From: yade-users-bounces+fchen3=utk.edu@xxxxxxxxxxxxxxxxxxx on behalf of
Ripudaman Manchanda
Sent: Wed 6/17/2009 10:12 AM
To: yade-users@xxxxxxxxxxxxxxxxxxx
Subject: [Yade-users] Modifying the geometry of the wall?


Hi,
 
I am working on a specific project and I need to know if I can make a hole
of specific dimensions at the bottom of a box such that grains (spheres) can
flow out under the application of stresses etc? 
 
I can proceed with YADE only if this is possible. Thank you.
 
Ripudaman Manchanda