yade-users team mailing list archive
-
yade-users team
-
Mailing list archive
-
Message #07563
Re: [Question #228778]: About considered facet's radius in Ig2_Facet_Sphere_ScGeom.
Question #228778 on Yade changed:
https://answers.launchpad.net/yade/+question/228778
Anton Gladky proposed the following answer:
Please, open a bugreport. We should check first, how it influences
results.
Thanks,
Anton
2013/5/13 Kneib François <question228778@xxxxxxxxxxxxxxxxxxxxx>
> New question #228778 on Yade:
> https://answers.launchpad.net/yade/+question/228778
>
> Hi,
>
> I found something weird in the source code into
> Ig2_Facet_Sphere_ScGeom::go().
> Usually when there is a contact between a sphere and a surface (wall, box
> ...), the contact geometry contains radius1=radius2=rs. (assuming rs is the
> sphere radius). So the stiffnesses of the contact are computed like if
> there is two spheres having the same radius.
>
> In Ig2_Box_Sphere_ScGeom::go :
> scm->radius1 = s->radius;
> scm->radius2 = s->radius;
>
> In Ig2_Wall_Sphere_ScGeom::go :
> ws->radius1=ws->radius2=radius;
>
> But into Ig2_Facet_Sphere_ScGeom::go, there is :
> scm->radius1 = 2*sphereRadius;
> scm->radius2 = sphereRadius;
>
> Don't you think this is a mistake ?
>
> --
> You received this question notification because you are a member of
> yade-users, which is an answer contact for Yade.
>
> _______________________________________________
> Mailing list: https://launchpad.net/~yade-users
> Post to : yade-users@xxxxxxxxxxxxxxxxxxx
> Unsubscribe : https://launchpad.net/~yade-users
> More help : https://help.launchpad.net/ListHelp
>
--
You received this question notification because you are a member of
yade-users, which is an answer contact for Yade.