yade-users team mailing list archive
-
yade-users team
-
Mailing list archive
-
Message #21154
Re: [Question #685523]: about CPM material model
Question #685523 on Yade changed:
https://answers.launchpad.net/yade/+question/685523
Status: Answered => Open
Othman Sh is still having a problem:
Jan,
Thanks for your reply, just to follow up on point 4, you said that the
elastic strain is limited by epsSoft, then plasticity starts. So to
control the stress-strain behavior in compression after epsSoft is
exceeded, I can use relKnSoft, right?
Also, in Yade documentation, "For commercial reasons, rate-dependence
and compression-plasticity is not present in reduced version of the
model, used when CPM_MATERIAL_MODEL is not defined". So is the CPM model
in the Yade 2018.02b is the full model or the reduced version with no
compression-plasticity?
Thanks,
Othman
--
You received this question notification because your team yade-users is
an answer contact for Yade.