yade-users team mailing list archive

[Leonard <question689498@xxxxxxxxxxxxxxxxxxxxx>]

Question #689498 on Yade changed:
https://answers.launchpad.net/yade/+question/689498

Leonard posted a new comment:
Thanks Bruno,

The reason why I'd like to confirm whether strain rate 1.0 is OK is that
I didn't see any paper (based on my limited literature review) who use
this strain rate, normally it is 0.01 or  0.0001 or ....

I just want to make sure that I adjust this parameter in a reasonable
range.

Cheers
Leonard

-- 
You received this question notification because your team yade-users is
an answer contact for Yade.