kicad-developers team mailing list archive

["Remy" <kicadder@...>]

--- In kicad-devel@xxxxxxxxxxxxxxx, Dick Hollenbeck <dick@...> wrote:
>
> Remy wrote:
> > Hi,
> > It seems there's a little bug when I export my design to freerouting.
> > I put screenshots in the files area, Kicadder's directory.
> > (This is NOT a top priority project :-))
> >
> > Regards
> > Remy
> >   
> 
> Remy,
> 
> I recently added support to show the end points of any edges pcb 
> segment. This happens when you select the edges pcb layer and then 
> click on the segment using the normal arrow tool.
> 
> Down in the status area you should see the two endpoints, including 
> endpoints for arcs or line segments.
> 
> I suggest that you verify that the two quarter arcs in the upper right 
> part of your board share a common point of intersection. This 
> intersection must be *exactly* the same.
> 
> You can do this by jotting down on paper the two endpoints of the first 
> 1/4 arc (the one going from North to East) and then do the same for
the 
> second one (the one going from North to West). Probably the point at 
> the North is not common, and needs to be exactly the same for the
export 
> to work properly. If this is not the case, then there is likely a
lack 
> of common point on the missing arc's West end, it must be *exactly* the 
> same as the Eastern most point of the arc to the missing arc's West.
> 
> I'm pretty sure there is no bug here. I may be out the next few
days, 
> so if there is more to this, and I don't respond, please be patient.
> 
> Dick
>

Hi Dick,
Thanks for your quick answer!
I will check these points, and contact you back if there are remaining
problems.
Thanks again.
Remy.