kicad-developers team mailing list archive

[Tomasz Wlostowski <tomasz.wlostowski@xxxxxxx>]

On 03/02/18 16:57, Steven A. Falco wrote:
> I have been using Kicad 4.0.7 successfully.  I just decided to give the upcoming 5 series a try, so I set up a Fedora VM and loaded the COPR 100:r11969.dc66b73-nightlies.fc27 build.
> 
> Most everything I've tried works fine, but zone fill in pcbnew just appears to hang.  Running "top" doesn't show anything sucking up time - it just never completes.
> 
> All that I get is a dialog box titled "Fill All Zones", with a message "Calculating zone fills...".  The Elapsed time counter shows 0:00:00, and the progress bar doesn't move.  If I click the Cancel button, it goes gray, but the box stays up.
> 
> The same thing happens if I try to run a DRC - as soon as it tries to fill zones, it hangs.  This board behaves properly in 4.0.7.  I even tried deleting the zones and re-adding them but that has no effect.
> 
> I've put the project, schematic, board file, etc up on dropbox in case anyone wants to take a look at it:
> 
> https://www.dropbox.com/sh/lw7lhg7jyigvyi7/AAB0ALAWmYS2LmOlw7-spqP6a?dl=0
> 
> I'll be happy to file a bug, but first I wanted to see if this is operator error or a known problem.
> 

Hi Steve,

You're using a build from 30 November 2017. Since then the freeze has
been fixed. Your board fills correctly on the latest nightly.

Tom