mythbuntu-bugs team mailing list archive
-
mythbuntu-bugs team
-
Mailing list archive
-
Message #00898
Re: [Bug 537856] Re: Daylight Savings Time screwup
Can you check the zap2it website and verify that it wasn't an issue with the
actual schedule?
On Wed, Mar 17, 2010 at 12:48 PM, DAP <Douglas_Peale@xxxxxxxxx> wrote:
> I don't think that is the same problem.
> My guide is correct.
> The problem was a single recording right after the 3 AM switch to daylight
> savings time was truncated to 10 minutes.
> So Myth TV does not handle recordings +- 1 hour of the switchover to
> daylight savings. Not a huge problem, in fact a much smaller problem then
> either of the two windows systems I have used, but still a bug.
>
> --
> Daylight Savings Time screwup
> https://bugs.launchpad.net/bugs/537856
> You received this bug notification because you are subscribed to
> Mythbuntu.
>
--
Daylight Savings Time screwup
https://bugs.launchpad.net/bugs/537856
You received this bug notification because you are a member of Mythbuntu
Bug Team, which is subscribed to Mythbuntu.
Status in Mythbuntu, Ubuntu derivative focused upon MythTV: New
Bug description:
Mythweb shows a scheduled recording at 3:55 AM for 10 minutes. Myth front end also shows this to be recorded from 3:55AM to 4:05 AM, also 10 minutes.
The schedule shows that the show should start at 3:00 AM and run until 4:00 AM, an hour. This show happens to be on the day of the switch to daylight savings time.
Attached is a screen shot for mythweb.
So, MythTV is not handling daylight savings time correctly.
I also have this system set up to automatically power up before recording. I have had two previous systems (both windows, two different manufacturers of HDTV card) that would power up for recordings, and they both screwed up daylight savings time every time, so I know to look for this.
This is the latest version of mythTV. I tested the HDHomerun config for someone and they had me switch to automatically update to the nightly build of MythTV so I could test it, but did not tell me how to switch back. I don't know how to get the actual build number.
References