nssbackup-team team mailing list archive

[Jean-Peer Lorenz <question62491@xxxxxxxxxxxxxxxxxxxxx>]

Question #62491 on NSsbackup changed:
https://answers.edge.launchpad.net/nssbackup/+question/62491

    Status: Open => Answered

Jean-Peer Lorenz proposed the following answer:
Ok, so obviously NSsbackup works so far. I did not understand exactly
what you meant by

>I can do a backup one of the configs I create, but no other config. It
starts, then stops immediately on the other configs.

Can you explain this again?

To finally resolve the problem, please try the following:

* run NSsbackup as superuser (from menu Administration->nssbackup configuration)
* open the profile manager and remove all profiles
* unselect all entries (but after removal there shouldn't be left one) and close the profile manager
* you should be back in the configuration window, check whether the current profile is the `Default profile` (it's written in the lower right corner of the window)
* re-configure the default profile to your needs (do not add any profiles at this moment)
* perform a backup using this default profile

Hopefully this works. If so, you can try to add a second profile and
configure this.

An important note: At the moment it is not possible to deactivate the
default profile. You have to set up a default profile since this is
executed each time.

Good luck. Jean-Peer

-- 
You received this question notification because you are a member of
NSsbackup team, which is an answer contact for NSsbackup.