opensand team mailing list archive

[Didier Barvaux <didier.barvaux@xxxxxxxxxxxxxxxxxxxx>]

> Dider,

Didier please. 


> > > 4. During deamon compilation strange things starts to happen.
> > > First I have lost ¨connection" with $OPENSAND_BASE_DIR
> > ...
> 
> > Yes, it's strange. Could you try to reproduce it please?
> >
> 
> I tried but nothing has happen so far. I'll try again with fresh
> ubuntu 12.04 desktop installation later on. We will see if it's
> possible.

OK.
 

> > > 5. Later on I have noticed that there is an error information
> > > which I atached in screen error log image. This problem apears
> > > during source compilation, and it stays after system reboot.
> > >
> >
> > It seems you did not configure the network for OpenSAND. Did you run
> > the instructions given there?
> >
> > http://opensand.org/support/wiki/doku.php?id=installation_manual&#configure_network_and_module_opensand-daemon
> >
> >
> I did but I forget to add # in first two lines. I presume that this
> small error in trunk - bug #1042681 is still present.

The '# if you downloaded an official release ' is only a comment, it is
not required.

Bug #1042681 is still present in trunk.

 
> > > 6. I decide to investigate what is wrong and I found out that
> > > there is some issue with python.. this time a bit different.
> > ..
> >
> > Did you installed the libnl and libnl-route packages as states
> > there?
> >
> > http://opensand.org/support/wiki/doku.php?id=installation_manual&#build_and_install_module_opensand-daemon
> >
> > If yes, these packages were done for Ubuntu 10.04 LTS. Ubuntu 12.04
> > provides packages for libnl and libnl-routes, so you can directly
> > use 'apt-get install libnl libnl-routes'.
> 
> Yes I did and now I know that this was serious mistake. I was about
> to add some log to this post but my server after upgrade crashed like
> desktop version before. I did suggested upgrade
> 
> 'sudo apt-get -f install' and 'apt-get install libnl libnl-routes'
> crashed like desktop version few days back. Now I have only memtest
> in my boot manager.
> 
> Any sugestion how to get back to my server when boot-loader is
> damaged ?? I haven't found any solid solution so far.

Try starting with a LiveCD and re-create your boot loader
configuration from the CD.

Regards,
Didier