qpdfview team mailing list archive

[Adam Reichold <question678113@xxxxxxxxxxxxxxxxxxxxx>]

Question #678113 on qpdfview changed:
https://answers.launchpad.net/qpdfview/+question/678113

    Status: Open => Answered

Adam Reichold proposed the following answer:
Hello,

qpdfview does not have an explicit default for things like the scale
mode and factor, rather whenever you explicit set these values, they
become the new default when you open a new tab. If you have to change
them every time, this seems to indicate that qpdfview is unable to
update to the new defaults.

It may take a few seconds until Qt writes out those settings to the
underlying configuration file, so if qpdfview crashes they might get
lost? Also if you have check the per-file settings, than those values
will be tracked per-file which also has precedence over the defaults?

Best regards,
Adam.

P.S.: The actual values are stored in ~/.confg/qpdfview/qpdfview.conf,
in the section [documentView] as scaleMode= and scaleFactor=.

-- 
You received this question notification because your team qpdfview is an
answer contact for qpdfview.