yade-dev team mailing list archive

[Anton Gladky <931263@xxxxxxxxxxxxxxxxxx>]

Hi Klaus,

it should be ok in r3026. There was a typo in a formulation.

Thanks for pointing that out.

Anton


2012/2/14 Klaus Thoeni <931263@xxxxxxxxxxxxxxxxxx>:
> Hi Anton,
>
> well done! The information shown by the localhost are fine now. The only thing
> which is still strange is that the estimated day/time when finished is wrong
> even if the iter/sec is more or less constant. It gives dates like 20 March
> whereas the simulation is finished in 5 minutes. Towards the end of the
> simulation (90%) it's getting more realistic. The same problem exists for
> simulations starting from the beginning.
>
> Not sure how the time/date is estimated. But since value iter/sec is correct
> it shouldn't behave so strange.
>
> Thanks,
> Klaus
>
> On Tue, 14 Feb 2012 08:07:57 AM Anton Gladky wrote:
>> I hope r3025 will fix the bug.
>
> --
> You received this bug notification because you are subscribed to Yade.
> https://bugs.launchpad.net/bugs/931263
>
> Title:
>  localhost info
>
> Status in Yet Another Dynamic Engine:
>  Fix Released
>
> Bug description:
>  When running a simulation, which has already some pre-history (e.g.
>  load a simulation which has done already 100000 iterations and run
>  some more simulations), in batch mode some information in localhost
>  info are wrong. I guess the average iterations per seconds include the
>  iterations from the loaded state. Therefore, the value is far to high
>  and the estimate for the finishing time/date is as well wrong. When
>  running without batch mode the controller is showing the correct
>  value.
>
> To manage notifications about this bug go to:
> https://bugs.launchpad.net/yade/+bug/931263/+subscriptions

-- 
You received this bug notification because you are a member of Yade
developers, which is the registrant for Yade.
https://bugs.launchpad.net/bugs/931263

Title:
  localhost info

Status in Yet Another Dynamic Engine:
  Fix Released

Bug description:
  When running a simulation, which has already some pre-history (e.g.
  load a simulation which has done already 100000 iterations and run
  some more simulations), in batch mode some information in localhost
  info are wrong. I guess the average iterations per seconds include the
  iterations from the loaded state. Therefore, the value is far to high
  and the estimate for the finishing time/date is as well wrong. When
  running without batch mode the controller is showing the correct
  value.

To manage notifications about this bug go to:
https://bugs.launchpad.net/yade/+bug/931263/+subscriptions