yade-dev team mailing list archive

[Klaus Thoeni <931263@xxxxxxxxxxxxxxxxxx>]

Yes, thanks Anton!

On Tue, 14 Feb 2012 05:42:19 PM Anton Gladky wrote:
> Hi Klaus,
> 
> it should be ok in r3026. There was a typo in a formulation.
> 
> Thanks for pointing that out.
> 
> Anton
> 
> 2012/2/14 Klaus Thoeni <931263@xxxxxxxxxxxxxxxxxx>:
> > Hi Anton,
> > 
> > well done! The information shown by the localhost are fine now. The only
> > thing which is still strange is that the estimated day/time when
> > finished is wrong even if the iter/sec is more or less constant. It
> > gives dates like 20 March whereas the simulation is finished in 5
> > minutes. Towards the end of the simulation (90%) it's getting more
> > realistic. The same problem exists for simulations starting from the
> > beginning.
> > 
> > Not sure how the time/date is estimated. But since value iter/sec is
> > correct it shouldn't behave so strange.
> > 
> > Thanks,
> > Klaus
> > 
> > On Tue, 14 Feb 2012 08:07:57 AM Anton Gladky wrote:
> >> I hope r3025 will fix the bug.
> > 
> > --
> > You received this bug notification because you are subscribed to Yade.
> > https://bugs.launchpad.net/bugs/931263
> > 
> > Title:
> >  localhost info
> > 
> > Status in Yet Another Dynamic Engine:
> >  Fix Released
> > 
> > Bug description:
> >  When running a simulation, which has already some pre-history (e.g.
> >  load a simulation which has done already 100000 iterations and run
> >  some more simulations), in batch mode some information in localhost
> >  info are wrong. I guess the average iterations per seconds include the
> >  iterations from the loaded state. Therefore, the value is far to high
> >  and the estimate for the finishing time/date is as well wrong. When
> >  running without batch mode the controller is showing the correct
> >  value.
> > 
> > To manage notifications about this bug go to:
> > https://bugs.launchpad.net/yade/+bug/931263/+subscriptions

-- 
You received this bug notification because you are a member of Yade
developers, which is the registrant for Yade.
https://bugs.launchpad.net/bugs/931263

Title:
  localhost info

Status in Yet Another Dynamic Engine:
  Fix Released

Bug description:
  When running a simulation, which has already some pre-history (e.g.
  load a simulation which has done already 100000 iterations and run
  some more simulations), in batch mode some information in localhost
  info are wrong. I guess the average iterations per seconds include the
  iterations from the loaded state. Therefore, the value is far to high
  and the estimate for the finishing time/date is as well wrong. When
  running without batch mode the controller is showing the correct
  value.

To manage notifications about this bug go to:
https://bugs.launchpad.net/yade/+bug/931263/+subscriptions