yade-users team mailing list archive
Mailing list archive
Re: hello? -help with a spinning bucket!
''(say between 10 and 40), this is not a crucial parameter yet.''
Ok. good enough for me, that is that problem dealt with. :-D
--- On Thu, 7/8/10, Bruno Chareyre <bruno.chareyre@xxxxxxxxxxx> wrote:
From: Bruno Chareyre <bruno.chareyre@xxxxxxxxxxx>
Subject: Re: [Yade-users] hello? -help with a spinning bucket!
Received: Thursday, July 8, 2010, 10:13 AM
It seems to me that if I put some beads into a container,
then tip the container, the angle at which they start flowing is the
angle of internal friction.. I am not at all sure of this, it seems
far to simple.
Not really. Angle of repose corresponds to "internal packing friction",
which "depends on" contact friction but is not equal.
Most materials have contact friction around 30°. Put this value at
contact in a loose sphere packing and you will get an internal friction
Anyway, you should get realistic results as soon as you define a decent
friction (say between 10 and 40), this is not a crucial parameter yet.
-----Inline Attachment Follows-----
Mailing list: https://launchpad.net/~yade-users
Post to : yade-users@xxxxxxxxxxxxxxxxxxx
Unsubscribe : https://launchpad.net/~yade-users
More help : https://help.launchpad.net/ListHelp