yade-users team mailing list archive

[Guilherme das Neves Seguro <question690803@xxxxxxxxxxxxxxxxxxxxx>]

New question #690803 on Yade:
https://answers.launchpad.net/yade/+question/690803

Hello everyone; 

greetings from Brazil.

I got a question about setting some boundary conditions on DFNFlow Engine.

I am simulating a flow through a cube that represents a rock matrix and when I'm setting stress forces and initial conditions (like rock properties, joint fractures and so on...) I use the following:

bottom = 0
[later on code]
,bndCondIsPressure = [0,0,bottom,0,0,0]

[later after all pre-set conditions and to start the flow]

bottom = 1 (to simulate a flow through the y axis)


My question is: should I set bndCondIsPressure as [0,0,0,0,0,0] when there is no flux? And as [0,0,1,0,0,0] when there is flux along the y axis? Or [0,0,1,1,0,0]?

Best regards and thanks in advance!

-- 
You received this question notification because your team yade-users is
an answer contact for Yade.