kicad-developers team mailing list archive
-
kicad-developers team
-
Mailing list archive
-
Message #01183
to: Dick Hollenbeck [Specctra dsn export]
Take a look at the 'pad properties' when exporting to specctra. I've
made a simple test - a board with only 1pin component.
.brd file differs by the following (pad active in <xxx> layers):
At STD N 00E00001 - Only copper layer
_____________8000 - Only comp layer
_____________FFFF - Both layers
_____________0000 - No layers at all
But the .dsn export file is the same in all cases!
Regards,
Vladimir.
Follow ups