kicad-developers team mailing list archive

[Dick Hollenbeck <dick@...>]

> Take a look at the 'pad properties' when exporting to specctra. I've
> made a simple test - a board with only 1pin component.
>
> .brd file differs by the following (pad active in <xxx> layers):
> At STD N 00E00001 - Only copper layer
> _____________8000 - Only comp layer
> _____________FFFF - Both layers
> _____________0000 - No layers at all
>
> But the .dsn export file is the same in all cases!
>
> Regards, 
> Vladimir.

The fix is in.

Dick