← Back to team overview

kicad-developers team mailing list archive

Re: to: Dick Hollenbeck [Specctra dsn export]

 

Dick Hollenbeck wrote:
klui_ wrote:

Take a look at the 'pad properties' when exporting to specctra. I've
made a simple test - a board with only 1pin component.

.brd file differs by the following (pad active in <xxx> layers):
At STD N 00E00001 - Only copper layer
_____________8000 - Only comp layer
_____________FFFF - Both layers
_____________0000 - No layers at all

But the .dsn export file is the same in all cases!

Regards, Vladimir.




Please send me the board, that will save me some time. Then I will look at it. Can you put an instance of each of the cases into the same board?


Thanks,

Dick


Vladimir,

Never mind about the sample board. I'll have a fix very shortly.

Dick






References