kicad-developers team mailing list archive

[Wayne Stambaugh <stambaughw@...>]

Dick Hollenbeck wrote:

<< snipped >>
> 
> When I say the ground symbol is separated from the wires, there is a 
> vertical gap in the newest software. Is it possible that there is a 
> different ground symbol being used, or is there something else at work here?

Uh Oh. I saw something similar in a schematic that I was working on as
well where some of the wire junctions had a vertical gap in them. I
believe it occurred after I switched grid sizes and then back but I
could not duplicate it after that and have not been able to duplicate it
since. I just thought it may have had something to do with a subtle
change from the previous release to the latest release. My schematic
did not have any custom power symbols. I'll try to open some of my
older projects and see if I can duplicate the error tomorrow.

Wayne

> 
> Dick